The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during the rear flexible hose removal/installation are shown below.
If both left and right front flexible hoses are disconnected at the same time, be sure to place an identification mark on each hose to indicate its installation position.
When the cable is disconnected/reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is operated normally
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
1.REMOVE REAR WHEEL
2.DRAIN BRAKE FLUID
Immediately wash off any brake fluid that comes into contact with any painted surfaces.
47319F
3.REMOVE REAR FLEXIBLE HOSE
Using a union nut wrench 10 mm, disconnect the brake tube while holding the rear flexible hose with a wrench.
Do not kink or damage the brake line.
Do not allow any foreign matter such as dirt and dust to enter the brake line.
Remove the clip and separate the rear flexible hose.
Using a union nut wrench 10 mm, disconnect the brake tube while holding the rear flexible hose with a wrench.
Do not kink or damage the brake line.
Do not allow any foreign matter such as dirt and dust to enter the brake line.
Remove the clip and rear flexible hose.