Home › General › MAINTENANCE › REAR BRAKE FLEXIBLE HOSE › 2020.03–2020.07
RM36W0E _V1 General _088300 MAINTENANCE _0425222 REAR BRAKE FLEXIBLE HOSE A

MAINTENANCE  REAR BRAKE FLEXIBLE HOSE  INSTALLATION  


PROCEDURE

Hide 47319F 1.INSTALL REAR FLEXIBLE HOSE

a.
C434971C01
1.865,2.875 2.177,3.073 0.313,0.198 10 false *a
*a Torque Wrench Fulcrum Length


Connect the rear flexible hose with new clip.

NOTICE:

Install the clip as far as it will go.



b.

Using a union nut wrench 10 mm, connect the brake tube to the rear flexible hose while holding the rear flexible hose with a wrench.

Torque:
Specified tightening torque : 15.2 N*m (155 kgf*cm, 11 ft.*lbf)

NOTICE:
·

Do not kink or damage the brake line.

·

Do not allow any foreign matter such as dirt or dust to enter the brake line from the connecting parts.



HINT:
·

Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION

·

When using a union nut wrench (fulcrum length of 22 mm (0.866 in.)) + torque wrench (fulcrum length of 162 mm (6.38 in.)): 13.4 N*m (137 kgf*cm, 10 ft.*lbf)




c.
C434970C01
1.74,2.979 2.052,3.177 0.313,0.198 10 false *a
*a Torque Wrench Fulcrum Length


Install the rear flexible hose with new clip.

NOTICE:

Install the clip as far as it will go.



d.

Using a union nut wrench 10 mm, connect the brake tube to the rear flexible hose while holding the rear flexible hose with a wrench.

Torque:
Specified tightening torque : 15.2 N*m (155 kgf*cm, 11 ft.*lbf)

NOTICE:
·

Do not kink or damage the brake line.

·

Do not allow any foreign matter such as dirt or dust to enter the brake line from the connecting parts.



HINT:
·

Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION

·

When using a union nut wrench (fulcrum length of 22 mm (0.866 in.)) + torque wrench (fulcrum length of 162 mm (6.38 in.)): 13.4 N*m (137 kgf*cm, 10 ft.*lbf)




Hide 2.CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL (for HV Model)

Hide 4.BLEED CLUTCH LINE (for Manual Transmission)

Hide 5.INSTALL REAR WHEEL

Hide 6. INITIALIZATION AFTER RECONNECTING AUXILIARY BATTERY TERMINAL (for HV Model)

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>WORK PROCEDURE

HINT:

When disconnecting and reconnecting the auxiliary battery, there is an automatic learning function that completes learning when the respective system is used.

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>AUTOMATIC LEARNING CHART