Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › TOYOTA PARKING ASSIST-SENSOR SYSTEM › 2020.03–2020.07
RM36W0E _56 Audio / Visual / Telematics _088657 PARK ASSIST / MONITORING _0425248 TOYOTA PARKING ASSIST-SENSOR SYSTEM J

PARK ASSIST / MONITORING  TOYOTA PARKING ASSIST-SENSOR SYSTEM  Clearance Warning ECU Power Source Circuit  


DESCRIPTION

This circuit provides power to operate the clearance warning ECU assembly.

WIRING DIAGRAM

E240921E71
5.271,1.771 5.583,1.969 0.313,0.198 10 false O60 5.271,1.948 6.802,2.396 1.531,0.448 10 false Clearance Warning ECU Assembly 5.573,1.302 5.729,1.5 0.156,0.198 10 false E 5.281,1.156 5.594,1.354 0.313,0.198 10 false 31 5.375,0.354 5.688,0.552 0.313,0.198 10 false 1 5.573,0.49 5.885,0.688 0.313,0.198 10 false IG 3.229,0.635 4.365,0.875 1.135,0.24 10 false ECU-IGR NO. 1 0.125,0.469 1.521,0.75 1.396,0.281 10 false from IGR-NO. 1 Relay

CAUTION / NOTICE / HINT

NOTICE:

Inspect the fuses for circuits related to this system before performing the following procedure.


PROCEDURE

1.CHECK HARNESS AND CONNECTOR (CLEARANCE WARNING ECU ASSEMBLY - BATTERY AND BODY GROUND)
a.

Disconnect the O60 clearance warning ECU assembly connector.


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
O60-31 (E) - Body ground Always Below 1 Ω



c.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Switch Condition Specified Condition
O60-1 (IG) - Body ground Ignition switch ON 11 to 14 V
O60-1 (IG) - Body ground Ignition switch off Below 1 V



Result:
Proceed to
OK
NG



OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR