Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › BLIND SPOT MONITOR SYSTEM › 2020.03–2020.07
RM36W0E _56 Audio / Visual / Telematics _088657 PARK ASSIST / MONITORING _0425251 BLIND SPOT MONITOR SYSTEM C

PARK ASSIST / MONITORING  BLIND SPOT MONITOR SYSTEM  U010087  Lost Communication with ECM/PCM "A" Missing Message  U012687  Lost Communication with Steering Angle Sensor Module Missing Message  U012987  Lost Communication with Brake System Control Module "A" Missing Message  U014087  Lost Communication with Body Control Module Missing Message  U029387  Lost Communication with Hybrid/EV Powertrain Control Module Missing Message  U111087  Lost Communication with Clearance Sonar Module Missing Message  


DESCRIPTION

These DTCs are stored if there is a malfunction in the CAN communication system connected to the blind spot monitor sensor.

HINT:

If CAN communication system DTCs are stored, they may also be stored for other systems.


DTC No. Detection Item DTC Detection Condition Trouble Area
U010087 Lost Communication with ECM/PCM "A" Missing Message Lost communication with ECM*1 CAN communication system
U012687 Lost Communication with Steering Angle Sensor Module Missing Message Lost communication with steering sensor CAN communication system
U012987 Lost Communication with Brake System Control Module "A" Missing Message Lost communication with skid control ECU CAN communication system
U014087 Lost Communication with Body Control Module Missing Message Lost communication with main body ECU (multiplex network body ECU) CAN communication system
U029387 Lost Communication with Hybrid/EV Powertrain Control Module Missing Message Lost communication with hybrid vehicle control ECU*2 CAN communication system
U111087 Lost Communication with Clearance Sonar Module Missing Message Lost communication with clearance warning ECU assembly CAN communication system

*1: for Gasoline Model

*2: for HV Model


CAUTION / NOTICE / HINT

NOTICE:

When checking for DTCs, make sure that the blind spot monitor system is turned on.


PROCEDURE

1.CHECK DTC
a.

Turn the ignition switch off.


b.

Turn the ignition switch to ON.


c.

Recheck for DTCs and check if the same DTC is output again.

Body Electrical > Blind Spot Monitor "B" > Trouble Codes
50001 460

Result:
Result Proceed to
Blind Spot Monitor LH (B) DTCs including DTC U023287 are output. A
Blind Spot Monitor LH (B) DTCs other than DTC U023287 are output. B
No DTCs are output C


HINT:
·

If CAN communication system DTCs are stored, they may also be stored for other systems.

·

If the CAN communication system has been inspected and repaired, the DTCs will not be output when rechecking for DTCs.

·

If these DTCs are output frequently, duplicate the conditions that cause the problem symptoms and perform the inspection again, even if the DTCs were not output when rechecking for DTCs.

Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING




A

B

C