The skid control ECU (brake booster with master cylinder assembly) stores the individual characteristic of each holding solenoid built into the brake actuator assembly. Based on the stored information, the skid control ECU (brake booster with master cylinder assembly) calibrates the individual differences and controls systems.
The skid control ECU (brake booster with master cylinder assembly) receives the park (P) signal from the hybrid vehicle control ECU through the CAN communication system.
These DTCs are cleared when the ABS holding solenoid valve learning results are normal.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | DTC Output from |
|---|---|---|---|---|
| C134951 | Pressure Holding Solenoid Valve Learning Not Programmed | The ABS holding solenoid valve learning value is not stored. | Perform ABS holding solenoid valve learning and check for DTCs. If no DTCs are output again, the valve is normal. | Brake |
| C134954 | Pressure Holding Solenoid Valve Learning Missing Calibration | The ABS holding solenoid valve learning value cannot be obtained. | ·
Perform ABS holding solenoid valve learning and check for DTCs. If no DTCs are output again, the valve is normal. ·
Skid control ECU (brake booster with master cylinder assembly) ·
Brake actuator assembly |
Brake |
After replacing the skid control ECU (brake booster with master cylinder assembly) or brake actuator assembly, perform linear solenoid valve offset learning, ABS holding solenoid valve learning, yaw rate and acceleration sensor zero point calibration and system information memorization after performing "Reset Memory".
Before performing linear solenoid valve offset learning, ABS holding solenoid valve learning, yaw rate and acceleration sensor zero point calibration and system information memorization, DTC C124A00 will be output.
Clear the DTCs.
Turn the ignition switch off.
| Proceed to |
|---|
| NEXT |
NEXT
Check that DTCs other than C134951 and C134954 are not output.
| Result | Proceed to |
|---|---|
| Only C134951 or C134954 is output | A |
| None of the above conditions are met | B |
A
B
Click hereBrake>BRAKE SYSTEM (OTHER)>BRAKE FLUID (for HV Model)>BLEEDING
| Proceed to |
|---|
| NEXT |
NEXT
Turn the ignition switch off.
Check and ensure the following conditions required for performing ABS holding solenoid valve learning and then perform ABS holding solenoid valve learning.
| Tester Display |
|---|
| ECB Utility |
The auxiliary battery voltage is 11 to 15.5 V when the ignition switch ON (READY).
The brake actuator assembly is not hot.
The hybrid control system is not malfunctioning.
The shift state indicator shows that the vehicle shift state is park (P).
The READY light in the combination meter assembly is illuminated.
The brake pedal is not depressed.
The parking brake is released.
Learning will be performed in the order of linear solenoid valve offset learning and then ABS holding solenoid valve learning.
| Proceed to |
|---|
| NEXT |
NEXT
Clear the DTCs.
Turn the ignition switch off.
| Proceed to |
|---|
| NEXT |
NEXT
Based on the Freeze Frame Data and interview with the customer, attempt to reproduce the conditions when the malfunction occurred.
Check if the same DTC is output.
| Result | Proceed to |
|---|---|
| C134951 and C134954 are not output | A |
| C134951 or C134954 is output | B |
A
B