If a malfunction is detected in the power source circuit, the skid control ECU (brake booster with master cylinder assembly) stores DTC C12C017 and prohibits operation of ABS, brake assist, regenerative brake cooperative control, etc.
DTC C12C017 is stored if an excessive ECU voltage due to a malfunction in the auxiliary battery, charging circuit, etc. is detected, and is cleared when the ECU voltage returns to normal.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | DTC Output from |
|---|---|---|---|---|
| C12C017 | Brake System Control Module Power Supply Voltage Circuit Voltage Above Threshold | The internal voltage of the skid control ECU (brake booster with master cylinder assembly) is 16.44 V or more for 0.8 seconds or more. | ·
Auxiliary battery ·
Hybrid control system (Charging circuit) ·
Wire harness or connector ·
Improperly connected connector, deformation or corrosion of terminals ·
Skid control ECU (brake booster with master cylinder assembly) |
Brake |
Refer to DTC C12C014.
After replacing the skid control ECU (brake booster with master cylinder assembly), perform linear solenoid valve offset learning, ABS holding solenoid valve learning, yaw rate and acceleration sensor zero point calibration and system information memorization after performing "Reset Memory".
Inspect the fuses for circuits related to this system before performing the following procedure.
Check the auxiliary battery voltage.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| Auxiliary battery | Ignition switch ON | 11 to 14 V |
| Auxiliary battery | Ignition switch ON (READY) | 11 to 15.5 V |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Turn the ignition switch off.
Make sure that there is no looseness at the locking part and the connecting part of the connector.
The connector is securely connected.
Disconnect the A38 skid control ECU (brake booster with master cylinder assembly) connector.
Check both the connector case and the terminals for deformation and corrosion.
No deformation or corrosion.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A38-15 (+BI1) - Body ground | Always | 11 to 14 V |
| A38-5 (+BI2) - Body ground | Always | 11 to 14 V |
| A38-52 (BS) - Body ground | Always | 11 to 14 V |
| A38-23 (IGR) - Body ground | Ignition switch ON | 11 to 14 V |
| A38-9 (IGP) - Body ground | Ignition switch ON | 11 to 14 V |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Turn the ignition switch off.
Reconnect the A38 skid control ECU (brake booster with master cylinder assembly) connector.
Clear the DTCs.
Turn the ignition switch off.
| Proceed to |
|---|
| NEXT |
NEXT
Based on the Freeze Frame Data and interview with the customer, attempt to reproduce the conditions when the malfunction occurred.
Check if the same DTC is output.
| Result | Proceed to |
|---|---|
| C12C017 is not output | A |
| C12C017 is output | B |
A
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
B