Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › ELECTRONICALLY CONTROLLED BRAKE SYSTEM (for HV Model) › 2020.03–2020.07
RM36W0E _54 Brake _088016 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0425342 ELECTRONICALLY CONTROLLED BRAKE SYSTEM(for HV Model) C

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  ELECTRONICALLY CONTROLLED BRAKE SYSTEM(for HV Model)  C145151  High Pressure Tube Air Bleeding Not Programmed  


DESCRIPTION

If air bleeding has not been performed, the skid control ECU (brake booster with master cylinder assembly) stores DTC C145151 to prevent the entry of air due to pump motor operation.

DTC C145151 is stored when Motor Invalid is selected, the system will not return to normal until the air bleeding procedure is performed.

DTC No. Detection Item DTC Detection Condition Trouble Area DTC Output from
C145151 High Pressure Tube Air Bleeding Not Programmed Either of the following is detected:
1.

Using the GTS, "Motor Invalid" of the "ECB Utility" has been performed.

2.

The brake booster with master cylinder assembly has been replaced.


Air bleeding not performed Brake

PROCEDURE

1.PERFORM AIR BLEEDING
a.

Bleed the air from the brake system.

Click hereBrake>BRAKE SYSTEM (OTHER)>BRAKE FLUID (for HV Model)>BLEEDING

HINT:

If air bleeding has been performed, this DTC will be cleared.



Result:
Proceed to
NEXT



NEXT

2.RECONFIRM DTC
2.RECONFIRM DTC
a.

Check if the same DTC is output.

Chassis > Brake > Trouble Codes
50001 435

Result:
Result Proceed to
C145151 is output A
C145151 is not output B



A

B

END