The accumulator pressure sensor is built into the brake booster with master cylinder assembly and detects the accumulator pressure.
If the skid control ECU (brake booster with master cylinder assembly) detects that the accumulator pressure sensor value is below the threshold, operation of the motor relay is requested and the pump motor built into the brake booster pump assembly operates.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | DTC Output from |
|---|---|---|---|---|
| C05732A | Brake Pressure Sensor "C" Signal Stuck In Range | When the pump motor is operating, the accumulator pressure sensor signal does not change for 14 seconds or more. | Skid control ECU (brake booster with master cylinder assembly) | Brake |
After replacing the skid control ECU (brake booster with master cylinder assembly), perform linear solenoid valve offset learning, ABS holding solenoid valve learning, yaw rate and acceleration sensor zero point calibration and system information memorization after performing "Reset Memory".
Clear the DTCs.
Turn the ignition switch off.
| Proceed to |
|---|
| NEXT |
NEXT
Turn the ignition switch to ON.
Depress the brake pedal 10 times or more to operate the pump motor.
After the pump motor stops, check for DTCs.
| Result | Proceed to |
|---|---|
| C05732A is not output | A |
| C05732A is output | B |
A
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
B