The airbag sensor assembly has a built-in yaw rate and acceleration sensor and detects the vehicle condition.
The skid control ECU (brake booster with master cylinder assembly) receives signals from the yaw rate and acceleration sensor (airbag sensor assembly) via the CAN communication system.
When a malfunction occurs in the communication line to the yaw rate and acceleration sensor (airbag sensor assembly), U012587 is output.
If a DTC related to the CAN communication line is output, first troubleshoot the CAN communication line.
A DTC may be stored if either of the following is detected:
Incorrect installation of acceleration sensor (airbag sensor assembly).
Abnormal acceleration sensor (airbag sensor assembly) signal.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | DTC Output from |
|---|---|---|---|---|
| C006396 | Yaw Rate Sensor Component Internal Failure | Yaw rate sensor internal malfunction signal is detected. | Yaw rate sensor (airbag sensor assembly) | Brake |
| C05201C | Multi-axis Acceleration Sensor Module "A" Circuit Voltage Out of Range | When the vehicle speed is 30 km/h (19 mph) or more, the difference between the deceleration value from the acceleration sensor and deceleration value calculated from the change in vehicle speed exceeds 0.35 G for 60 seconds or more. | ·
Acceleration sensor (airbag sensor assembly) installed improperly ·
Acceleration sensor (airbag sensor assembly) |
Brake |
| C05202A | Multi-axis Acceleration Sensor Module "A" Signal Stuck In Range | When the vehicle speed is 10 km/h (6 mph) or more, the acceleration sensor output value does not change for 30 seconds or more. | ·
Acceleration sensor (airbag sensor assembly) installed improperly ·
Acceleration sensor (airbag sensor assembly) |
Brake |
| C052096 | Multi-axis Acceleration Sensor Module "A" Component Internal Failure | Any of the following is detected:
·
The acceleration sensor output value does not change 16 times or more before the vehicle speed reaches 0 km/h (0 mph) from 30 km/h (19 mph). ·
The longitudinal and lateral output values of the acceleration sensor are not within the specified range for 60 seconds or more. ·
The lateral output value of the acceleration sensor is not within the specified range for 60 seconds or more. |
·
Acceleration sensor (airbag sensor assembly) installed improperly ·
Acceleration sensor (airbag sensor assembly) |
Brake |
After replacing or reinstalling the yaw rate and acceleration sensor (airbag sensor assembly), perform "Calibration" after performing "Reset Memory".
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>CENTER AIRBAG SENSOR ASSEMBLY>REMOVAL
| Proceed to |
|---|
| NEXT |
NEXT