Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › ENTRY AND START SYSTEM (for Entry Function, HV Model) › 2020.03–2020.07
RM36W0E _58 Vehicle Interior _087476 THEFT DETERRENT / KEYLESS ENTRY _0424971 ENTRY AND START SYSTEM(for Entry Function, HV Model) J

THEFT DETERRENT / KEYLESS ENTRY  ENTRY AND START SYSTEM(for Entry Function, HV Model)  Entry Exterior Alarm and Answer-back Buzzer do not Sound  


DESCRIPTION

The entry and start system (for Entry Function) uses the wireless door lock buzzer to perform various vehicle exterior warnings. When the conditions of each warning are met, the certification ECU (smart key ECU assembly) sends a buzzer activation request signal to the main body ECU (multiplex network body ECU) via CAN communication and the buzzer sounds.

WIRING DIAGRAM

B506724E10
0.635,3.25 2.438,3.521 1.802,0.271 10 false : CAN Communication Line 3.552,2.698 5.208,3.281 1.656,0.583 10 false Main Body ECU (Multiplex Network Body ECU) 2.438,1.74 3.875,2.24 1.438,0.5 10 false Power Distribution Box Assembly 2.438,1.563 2.875,1.865 0.438,0.302 10 false 4D 5.542,2.667 7.052,3.177 1.51,0.51 10 false Certification ECU (Smart Key ECU Assembly) 0.406,1.625 1.667,2.167 1.26,0.542 10 false Wireless Door Lock Buzzer 3.552,2.542 3.99,2.844 0.438,0.302 10 false MB 0.406,1.469 0.844,1.771 0.438,0.302 10 false A57 2.458,0.938 2.896,1.24 0.438,0.302 10 false 7 1.729,0.938 2.167,1.24 0.438,0.302 10 false 1 0.51,0.938 0.948,1.24 0.438,0.302 10 false 2 3.76,0.927 4.198,1.229 0.438,0.302 10 false 3 0.677,0.938 1.115,1.24 0.438,0.302 10 false E 1.531,0.938 1.969,1.24 0.438,0.302 10 false B 3.958,0.938 4.396,1.24 0.438,0.302 10 false BZR 4.25,0.531 4.688,0.833 0.438,0.302 10 false +B

CAUTION / NOTICE / HINT

NOTICE:
·

When using the GTS with the ignition switch off, connect the GTS to the DLC3 and turn a courtesy light switch on and off at intervals of 1.5 seconds or less until communication between the GTS and the vehicle begins. Then select Model Code "KEY REGIST" under manual mode and enter the following menus: Body Electrical / Entry&Start(CAN). While using the GTS, periodically turn a courtesy light switch on and off at intervals of 1.5 seconds or less to maintain communication between the GTS and the vehicle.

·

The entry and start system (for Entry Function) uses the CAN communication system. Inspect the communication function by following How to Proceed with Troubleshooting. Troubleshoot the entry and start system (for Entry Function) after confirming that the communication systems are functioning properly.

Click hereVehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>ENTRY AND START SYSTEM (for Entry Function, HV Model)>HOW TO PROCEED WITH TROUBLESHOOTING

·

Before replacing the certification ECU (smart key ECU assembly) or main body ECU (multiplex network body ECU), refer to Service Bulletin.

·

After repair, confirm that no DTCs are output.



PROCEDURE

1.CHECK CUSTOMIZE SETTING (WIRELESS BUZZER RESP)
a.

Check customize setting.

Wireless Door Lock
Tester Display Description Default Setting ECU
Wireless Buzzer Response Function Wireless buzzer response Enable $00:Disable,$01:Enable Main body ECU (multiplex network body ECU)
50006 1

Result:
Result Proceed to
"Enable" is displayed A
"Disable" is displayed B



A

2.CHECK WIRELESS DOOR LOCK CONTROL SYSTEM

B

2.CHECK WIRELESS DOOR LOCK CONTROL SYSTEM

Result:
Result Proceed to
Wireless door lock function operates normally A
Wireless door lock function does not operate normally B



A

3.READ VALUE USING GTS (EACH UNLOCK DETECTION SWITCH)

B

3.READ VALUE USING GTS (EACH UNLOCK DETECTION SWITCH)
a.

Read the Data List according to the display on the GTS.

Body Electrical > Main Body > Data List
Tester Display Measurement Item Range Normal Condition Diagnostic Note
FR Door Lock Position Switch Status Front door RH unlock detection switch signal Lock or Unlock Lock: Front door RH locked
Unlock: Front door RH unlocked
-
FL Door Lock Position Switch Status Front door LH unlock detection switch signal Lock or Unlock Lock: Front door LH locked
Unlock: Front door LH unlocked
-
RR Door Lock Position Switch Status Rear door RH unlock detection switch signal Lock or Unlock Lock: Rear door RH locked
Unlock: Rear door RH unlocked
-
RL Door Lock Position Switch Status Rear door LH unlock detection switch signal Lock or Unlock Lock: Rear door LH locked
Unlock: Rear door LH unlocked
-
Body Electrical > Main Body > Data List
Tester Display
FR Door Lock Position Switch Status
FL Door Lock Position Switch Status
RR Door Lock Position Switch Status
RL Door Lock Position Switch Status
50003 449 20,21,22,23
OK:

The GTS display changes correctly in response to the lock/unlock operation.



Result:
Proceed to
OK
NG



OK

4.PERFORM ACTIVE TEST USING GTS (WIRELESS BUZZER)

NG

GO TO LIGHTING SYSTEM (Proceed to Door Unlock Detection Switch Circuit)

4.PERFORM ACTIVE TEST USING GTS (WIRELESS BUZZER)
a.

Perform Active Test according to the display on the GTS.

Body Electrical > Main Body > Active Test
Tester Display Measurement Item Control Range Diagnostic Note
Wireless Buzzer Wireless door lock buzzer OFF/ON -
Body Electrical > Main Body > Active Test
Tester Display
Wireless Buzzer
50004 449 31

Result:
Result Proceed to
Wireless door lock buzzer does not sound A
Wireless door lock buzzer sounds B



A

GO TO WIRELESS DOOR LOCK CONTROL SYSTEM (NO ANSWER-BACK)

B

REPLACE CERTIFICATION ECU (SMART KEY ECU ASSEMBLY)