The airbag sensor assembly has a built-in yaw rate and acceleration sensor and detects the vehicle condition.
The skid control ECU (brake booster with master cylinder assembly) receives signals from the yaw rate and acceleration sensor (airbag sensor assembly) via CAN communication.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | DTC Output from |
|---|---|---|---|---|
| C00631F | Yaw Rate Sensor Circuit Intermittent | When voltage at terminal IGR is 9.54 V or more, sensor invalid information received from yaw rate sensor is ON continuously for 10 seconds or more. | ·
Yaw rate sensor (airbag sensor assembly) ·
Yaw rate sensor (airbag sensor assembly) installed improperly |
Brake |
| C05201F | Multi-axis Acceleration Sensor Module "A" Circuit Intermittent | When voltage at terminal IGR is 9.54 V or more, sensor invalid information received from acceleration sensor is ON continuously for 10 seconds or more. | ·
Acceleration sensor (airbag sensor assembly) ·
Acceleration sensor (airbag sensor assembly) installed improperly |
Brake |
After replacing or reinstalling the yaw rate and acceleration sensor (airbag sensor assembly), perform "Calibration" after performing "Reset Memory".
Clear the DTCs.
Turn the ignition switch off.
| Proceed to |
|---|
| NEXT |
NEXT
Based on the Freeze Frame Data and interview with the customer, attempt to reproduce the conditions when the malfunction occurred.
Check if the same DTC is output.
| Result | Proceed to |
|---|---|
| C00631F and C05201F are not output | A |
| C00631F or C05201F is output | B |
A
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
B