Home › Brake › PARKING BRAKE › PARKING BRAKE SWITCH
RM36W0E _54 Brake _089430 PARKING BRAKE _0424721 PARKING BRAKE SWITCH G

PARKING BRAKE  PARKING BRAKE SWITCH  INSPECTION  


PROCEDURE

Hide 84550 1.INSPECT PARKING BRAKE SWITCH ASSEMBLY

a.
C300450C04
2.583,0.385 3.031,0.615 0.448,0.229 2.313,0.917 2.844,0.917 true 0.958,1.083 0.958,1.281 0.958,1.281 1.167,1.281 true 2.156,0.823 2.469,0.979 0.313,0.156 10 false 1 1.219,1.198 1.531,1.354 0.313,0.156 10 false *a 0.052,0.729 0.365,0.885 0.313,0.156 10 false *b 0.531,0.729 0.844,0.885 0.313,0.156 10 false *c 2.698,0.427 3.104,0.625 0.406,0.198 10 false H37
*a Body Ground
*b ON
*c OFF


Measure the resistance between the connector terminal and the nut inside the parking brake switch assembly.

Standard Resistance
Tester Connection Condition Specified Condition
H37-1 - H37-Body ground On (When shaft is not pressed) Below 1 Ω
H37-1 - H37-Body ground Off (When shaft is pressed) 10 kΩ or higher

If the result is not as specified, replace the parking brake switch assembly.