COMMUNICATION SYSTEM FUNCTION
The air conditioning amplifier assembly communicates with each ECU via CAN communication and LIN communication. Additionally, the air conditioning amplifier assembly sends operation signals to each damper servo motor and receives damper position information and sensor information from the damper servo motors and No. 1 cooler thermistor through the air conditioning harness assembly.
| Receiver | Sender | Signal | Communication Line |
|---|---|---|---|
| Air conditioning amplifier assembly | Central gateway ECU (network gateway ECU) | BDB1F03 Sub ID | CAN |
| BDB1F03 INFO | |||
| Trip count | |||
| Time count |
| Receiver | Sender | Signal | Communication Line |
|---|---|---|---|
| Air conditioning amplifier assembly | Main body ECU (multiplex network body ECU) | BDB1S01 Sub ID | CAN |
| BDB1S01 INFO | |||
| High beam head lamp request | |||
| Low beam head lamp request | |||
| BDB1S08 Sub ID | |||
| BDB1S08 INFO | |||
| Destination symbol | |||
| Country code 1st | |||
| Country code 2nd | |||
| Country code 3rd | |||
| Steering wheel | |||
| Main body ECU (multiplex network body ECU) | Air conditioning amplifier assembly | Ambient temperature display signal | CAN |
| Receiver | Sender | Signal | Communication Line |
|---|---|---|---|
| Air conditioning amplifier assembly | ECM | Engine RPM data | CAN |
| A/C control cut-off signal 5 | |||
| A/C control cut-off signal 4 | |||
| A/C control cut-off signal 3 | |||
| A/C control cut-off signal 2 | |||
| A/C control cut-off signal 1 | |||
| Variable control inhibition signal | |||
| Air conditioner cut-off instruction flag at deceleration | |||
| A/C super cooling command flag at deceleration | |||
| Number of PTC heater which is permitted | |||
| A/C lubrication control inhibit | |||
| Engine type information 1 | |||
| Engine type information 2 | |||
| Engine type information 3 | |||
| Engine type information 4 | |||
| Transmission information | |||
| Power train system | |||
| Alternative field duty value | |||
| Power management demand signal | |||
| Engine outlet coolant temperature | |||
| ECM | Air conditioning amplifier assembly | Magnet clutch request signal | CAN |
| A/C idle up request signal | |||
| Heater idle up request signal | |||
| Super cooling control state signal | |||
| Charging control inhibit signal | |||
| Motor cooling fan drive request signal | |||
| Prior A/C control request signal | |||
| Acceleration cut inhibit signal | |||
| LOCK-UP INHIBIT signal | |||
| PTC Heater control request signal | |||
| Generator control inhibit signal | |||
| Request control by refrigerant | |||
| Ambient temperature before correction signal | |||
| Refrigerant information | |||
| The first advancement evaporator temperature | |||
| Variable compressor solenoid current signal | |||
| Refrigerant gas pressure sensor signal | |||
| Ambient temperature display signal | |||
| A/C control state signal |
| Receiver | Sender | Signal | Communication Line |
|---|---|---|---|
| Air conditioning amplifier assembly | ECM | Engine RPM data | CAN |
| A/C control cut-off signal 5 | |||
| A/C control cut-off signal 4 | |||
| A/C control cut-off signal 3 | |||
| A/C control cut-off signal 2 | |||
| A/C control cut-off signal 1 | |||
| Variable control inhibition signal | |||
| Air conditioner cut-off instruction flag at deceleration | |||
| A/C super cooling command flag at deceleration | |||
| Number of PTC heater which is permitted | |||
| A/C lubrication control inhibit | |||
| Engine type information 1 | |||
| Engine type information 2 | |||
| Engine type information 3 | |||
| Engine type information 4 | |||
| Transmission information | |||
| Power train system | |||
| Alternative field duty value | |||
| Power management demand signal | |||
| Engine outlet coolant temperature | |||
| ECM | Air conditioning amplifier assembly | Magnet clutch request signal | CAN |
| A/C idle up request signal | |||
| Heater idle up request signal | |||
| Super cooling control state signal | |||
| Charging control inhibit signal | |||
| Prior A/C control request signal | |||
| Acceleration cut inhibit signal | |||
| LOCK-UP INHIBIT signal | |||
| PTC Heater control request signal | |||
| Generator control inhibit signal | |||
| Request control by refrigerant | |||
| Heating performance assistance request signal to transmission system | |||
| Ambient temperature before correction signal | |||
| Refrigerant information | |||
| The first advancement evaporator temperature | |||
| Electricity load at low voltage state signal | |||
| Variable compressor solenoid current signal | |||
| Refrigerant gas pressure sensor signal | |||
| Ambient temperature display signal | |||
| Heater priority request | |||
| FSV close request | |||
| Minimum heater flow request |
| Receiver | Sender | Signal | Communication Line |
|---|---|---|---|
| Air conditioning amplifier assembly | Engine stop and start ECU | Eco-run control mode | CAN |
| S&S A/C MODE | |||
| S&S lamp lighting request | |||
| Engine stop and start ECU | Air conditioning amplifier assembly | Engine ON request signal | CAN |
| Ambient temperature display signal |
| Receiver | Sender | Signal | Communication Line |
|---|---|---|---|
| Air conditioning amplifier assembly | Combination meter assembly | FRN1S01 Sub ID | CAN |
| FRN1S01 INFO | |||
| Ambient temp display | |||
| Outside temperature sensor data | |||
| MET1S01 Sub ID | |||
| MET1S01 INFO | |||
| Vehicle speed signal (meter to other) | |||
| MET1S02 Sub ID | |||
| MET1S02 INFO | |||
| Odometer unit signal | |||
| Odometer signal |
| Receiver | Sender | Signal | Communication Line |
|---|---|---|---|
| Air conditioning amplifier assembly | Power distribution box assembly | Presence/absence of PTC | CAN |
| Power distribution box assembly | Air conditioning amplifier assembly | PTC heater relay request signal | CAN |
| Receiver | Sender | Signal | Communication Line |
|---|---|---|---|
| Air conditioning amplifier assembly | Power steering ECU assembly | Loading control level | CAN |
| Receiver | Sender | Signal | Communication Line |
|---|---|---|---|
| Air conditioning amplifier assembly | Telematics transceiver | RSE1G20 Sub ID | CAN |
| RSE1G20 INFO | |||
| Date and time information of DCM (YEAR) | |||
| Date and time information of DCM (MONTH) | |||
| Date and time information of DCM (DAY) | |||
| Date and time information of DCM (HOUR) | |||
| Date and time information of DCM (MINUTES) | |||
| Date and time information of DCM (SECOND) | |||
| Telematics transceiver | Air conditioning amplifier assembly | Drive recorder ACN01 | CAN |
| Drive recorder ACN02 | |||
| Drive recorder ACN03 | |||
| Drive recorder ACN04 | |||
| Drive recorder ACN05 | |||
| Drive recorder ACN06 | |||
| Drive recorder ACN07 | |||
| Drive recorder ACN08 | |||
| Ambient temperature display signal | |||
| A/C control state signal |
| Receiver | Sender | Signal | Communication Line |
|---|---|---|---|
| Air conditioning amplifier assembly | Air conditioner pressure sensor | Sensor value signal | Direct line |
| No. 1 cooler thermistor | |||
| Blower motor with fan sub-assembly | Air conditioning amplifier assembly | Drive signal | Direct line |