31470
1.INSTALL CLUTCH RELEASE CYLINDER ASSEMBLY
Install the clutch release cylinder assembly with the 2 bolts.
31482
2.CONNECT CLUTCH RELEASE CYLINDER TO FLEXIBLE HOSE TUBE
| *a | Torque Wrench Fulcrum Length |
Using a 10 mm union nut wrench, connect the clutch release cylinder to flexible hose tube to the clutch release cylinder assembly.
Do not kink or damage the clutch release cylinder to flexible hose tube.
Do not allow any foreign matter such as dirt or dust to enter the clutch release cylinder to flexible hose tube from the connecting part.
Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
When using a union nut wrench (fulcrum length of 22 mm (0.866 in.)) + torque wrench (fulcrum length of 162 mm (6.38 in.)): 13.4 N*m (137 kgf*cm, 10 ft.*lbf)
31461
3.INSTALL RELEASE CYLINDER HEAT INSULATOR
Install the release cylinder heat insulator to the clutch release cylinder assembly with the 2 bolts.
4.BLEED CLUTCH LINE
5.INSPECT FOR BRAKE FLUID LEAK
6.INSPECT BRAKE FLUID LEVEL IN RESERVOIR