Home › Drivetrain › DRIVE SHAFT / PROPELLER SHAFT › FRONT DRIVE SHAFT ASSEMBLY (for M15A-FKS TMMF Made) › from 2020.07
RM36W0E _52 Drivetrain _087547 DRIVE SHAFT / PROPELLER SHAFT _0430980 FRONT DRIVE SHAFT ASSEMBLY(for M15A-FKS TMMF Made) G

DRIVE SHAFT / PROPELLER SHAFT  FRONT DRIVE SHAFT ASSEMBLY(for M15A-FKS TMMF Made)  INSPECTION  


PROCEDURE

Hide 1.INSPECT FRONT DRIVE SHAFT ASSEMBLY

a.
C211744

Check that there is no excessive play in the radial direction of the outboard joint.


b.

Check that the inboard joint slides smoothly in the thrust direction.


c.

Check that there is no excessive play in the radial direction of the inboard joint.


d.

Check the boots for damage.


e.
C296188N01
1.438,1.656 1.594,1.854 0.156,0.198 10 false A

Check whether each drive shaft dimension (A) is within specification.

Dimension (A):
for CVT for LH Side 624.1 mm (2.05 ft.)
for RH Side 839.1 mm (2.75 ft.)
for Manual Transaxle for LH Side 624.1 mm (2.05 ft.)
for RH Side 837.1 mm (2.75 ft.)


NOTICE:

Keep the drive shaft assembly level during inspection.