| *a | Tube |
Do not disconnect the tube shown in the illustration when disassembling the fuel suction tube with pump and gauge assembly. Doing so will cause reassembly of the fuel suction tube with pump and gauge assembly to be impossible as the tube is pressed into the fuel suction plate sub-assembly.
83320
1.REMOVE FUEL SENDER GAUGE ASSEMBLY
23221
2.REMOVE FUEL PUMP
Disconnect the fuel pump harness connector.
Disengage the clamp and disconnect the fuel pump harness from the fuel suction tube with pump and gauge assembly.
Do not damage the wire harness.
When disengaging each wire harness from the clamp, disengage one wire at a time.
| *1 | Fuel Suction Plate Sub-assembly |
|
Pull |
|
Slide |
Disengage the claw and slide the fuel suction plate sub-assembly and then separate it from the fuel sub-tank sub-assembly.
Disengage the 4 claws and remove the fuel pump from the fuel sub-tank sub-assembly.
Do not do anything which may separate the tube from either the plate sub-assembly or fuel filter, such as applying excessive force to the tube.
Click hereEngine / Hybrid System>1KR-FE (FUEL)>FUEL SYSTEM>PRECAUTION
| *a | No. 1 Fuel Suction Support |
Disengage the 3 claws, and remove the fuel pump from the No. 1 fuel suction support.
Disconnect the fuel pump harness connector.
| *1 | O-ring |
| *2 | Fuel Pump Spacer |
Remove the O-ring and fuel pump spacer from the fuel pump.
Be careful not to damage the sealing surface.