Home › Engine / Hybrid System › 1KR-FE (EMISSION CONTROL) › DIFFERENTIAL PRESSURE SENSOR › from 2020.07
RM36W0E _51 Engine / Hybrid System _090964 1KR-FE EMISSION CONTROL _0431147 DIFFERENTIAL PRESSURE SENSOR A

1KR-FE EMISSION CONTROL  DIFFERENTIAL PRESSURE SENSOR  INSTALLATION  


PROCEDURE

Hide 25760 1.CONNECT VACUUM TRANSMITTING HOSE ASSEMBLY

a.

Connect a new vacuum transmitting hose assembly to the No. 1 pipe and slide the clip to secure the hose.


Hide 89481B 2.INSTALL DIFFERENTIAL PRESSURE SENSOR

a.

Install the sensor bracket to the cylinder head cover sub-assembly with the 2 bolts.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)


b.

Install the differential pressure sensor to the sensor bracket with the bolt.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)


c.
A468002C01
1.396,1.948 1.708,2.104 0.313,0.156 10 false *a 0.938,1.396 1.25,1.552 0.313,0.156 10 false *b 0.323,1.927 0.635,2.083 0.313,0.156 10 false *c
*a Rear of Vehicle
*b Right Side of Vehicle
*c 90°


Connect the vacuum transmitting hose assembly to the differential pressure sensor and slide the clip to secure it.

HINT:

Install the vacuum transmitting hose assembly and hose clamps as shown in the illustration.



d.

Connect the differential pressure sensor connector.


Hide 89481B 3.LEARNING DIFFERENTIAL PRESSURE SENSOR

a.

Start the engine and allow it to idle until the engine coolant temperature reaches 75°C (167°F) or higher (A).


b.

Turn the ignition switch off and wait for 30 seconds or more (B).


c.

Repeat the above procedures (A) and (B) 3 times.

HINT:

Procedures (A) and (B) must be repeated 3 times to complete the differential pressure sensor learning process.