The speed limiter system uses the wheel speed signal that is sent from the skid control ECU (brake actuator assembly).
This DTC indicates a malfunction in a wheel speed sensor of the skid control ECU (brake actuator assembly).
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| P157804 | Brake System System Internal Failure | Information of wheel speed sensor malfunction is received from the skid control ECU (brake actuator assembly). | ·
Electronically controlled brake system ·
Wheel speed sensor ·
Hybrid vehicle control ECU |
When this DTC is stored, speed limiter system operation will be prohibited. Even after DTCs are cleared, operation of the speed limiter system will remain prohibited until the following is performed.
Turn the ignition switch from off to ON, drive the vehicle at a speed of 15 km/h (9 mph) or more for at least 10 seconds, then turn the speed limiter system on.
Before replacing the hybrid vehicle control ECU, refer to Service Bulletin.
The DTCs related to the electronically controlled brake system system will be stored at the same time. In that case, perform troubleshooting for the electronically controlled brake system first.
When DTC U012200 is stored, DTC P157804 may be stored at the same time. Therefore perform troubleshooting for DTC U012200 first.
Check for DTCs.
| Result | Proceed to |
|---|---|
| DTC U012200 is not output | A |
| DTC U012200 is output | B |
A
B
Check for DTCs.
| Result | Proceed to |
|---|---|
| DTCs are not output | A |
| DTCs are output | B |
A
B
Clear the DTCs.
Perform the following to make sure that the DTC detection conditions are met.
If the detection conditions are not met, the malfunction cannot be detected.
Drive the vehicle at a speed for which speed limiter system operation is possible.
Turn the speed limiter system on and drive the vehicle for more than 10 seconds.
Check for DTCs.
| Result | Proceed to |
|---|---|
| DTC P157804 is not output | A |
| DTC P157804 is output | B |
A
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
B