Home › Engine / Hybrid System › CRUISE CONTROL › SPEED LIMITER SYSTEM (for HV Model) › from 2020.07
RM36W0E _51 Engine / Hybrid System _088664 CRUISE CONTROL _0431302 SPEED LIMITER SYSTEM(for HV Model) C

CRUISE CONTROL  SPEED LIMITER SYSTEM(for HV Model)  U012200  Lost Communication with Vehicle Dynamics Control Module  


DESCRIPTION

The hybrid vehicle control ECU communicates with each sensor and ECU via CAN communication.

If there are any malfunctions in the communication circuit, one or more CAN communication system DTCs are stored.

DTC No. Detection Item DTC Detection Condition Trouble Area
U012200 Lost Communication with Vehicle Dynamics Control Module While speed limiter is operating, communication stop between skid control ECU (brake actuator assembly) and hybrid vehicle control ECU is detected. CAN communication system

CAUTION / NOTICE / HINT

NOTICE:

When this DTC is stored, speed limiter system operation will be prohibited. Even after DTCs are cleared, operation of the speed limiter system will remain prohibited until the following is performed.

·

Turn the ignition switch from off to ON, drive the vehicle at a speed of 15 km/h (9 mph) or more for at least 10 seconds, then turn the speed limiter system on.



PROCEDURE

1.GO TO CAN COMMUNICATION SYSTEM
HINT:

Refer to CAN Communication System.

Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM (for HV Model)>HOW TO PROCEED WITH TROUBLESHOOTING


Result:
Proceed to
NEXT



NEXT

END