Home › Engine / Hybrid System › 1KR-FE (ENGINE MECHANICAL) › CYLINDER HEAD › from 2020.07
RM36W0E _51 Engine / Hybrid System _091035 1KR-FE ENGINE MECHANICAL _0431332 CYLINDER HEAD A

1KR-FE ENGINE MECHANICAL  CYLINDER HEAD  REPAIR  


PROCEDURE

Hide 1.REPAIR INTAKE VALVE SEAT

NOTICE:
·

Repair the valve seat while checking the seating position.

·

Keep the lip free from foreign matter.

·

Release the cutter gradually to make the valve seat smooth.



a.
A324489C01
1.958,1.521 2.938,1.25 true 3,1.135 3.313,1.333 0.313,0.198 10 false *a
*a Cutter


Using a 45° cutter, resurface the valve seat so that the valve seat width is more than the standard.


b.
A324490C01
2.021,1.76 2.302,1.969 0.281,0.208 10 false *a 2.365,0.573 2.698,0.792 0.333,0.219 10 false 60° 2.198,0.906 2.531,1.125 0.333,0.219 10 false 45° 2.021,1.281 2.354,1.5 0.333,0.219 10 false 30°
*a Valve Seat Contact


Using 30° and 70° cutters, resurface the valve seat so that the valve contacts the entire circumference of the seat. The contact should be in the center of the valve seat, and the valve seat width should be maintained within the specified range around the entire circumference of the seat.

Standard Valve Seat Width:

1.0 to 1.4 mm (0.0394 to 0.0551 in.)



c.

Hand lap the valve and valve seat with an abrasive compound.


d.

Check the valve seating position.


Hide 2.REPAIR EXHAUST VALVE SEAT

NOTICE:
·

Repair the valve seat while checking the seating position.

·

Keep the lip free from foreign matter.

·

Release off the cutter gradually to make the valve seat smooth.



a.
A322050C01
1.448,1.583 2.146,0.938 true 2.219,0.833 2.531,0.99 0.313,0.156 10 false *a
*a Cutter


Using a 45° cutter, resurface the valve seat so that the valve seat width is more than the standard.


b.
A324491C01
2.021,1.771 2.313,1.979 0.292,0.208 10 false *a 2.344,0.531 2.688,0.74 0.344,0.208 10 false 75° 2.208,0.927 2.552,1.135 0.344,0.208 10 false 45° 2.021,1.302 2.365,1.51 0.344,0.208 10 false 20°
*a Valve Seat Contact


Using 20° and 75° cutters, resurface the valve seat so that the valve contacts the entire circumference of the seat. The contact should be in the center of the valve seat, and the valve seat width should be maintained within the specified range around the entire circumference of the seat.

Standard Valve Seat Width:

1.0 to 1.4 mm (0.0394 to 0.0551 in.)



c.

Hand lap the valve and valve seat with an abrasive compound.


d.

Check the valve seating position.