1.REMOVE INTAKE VALVE
Place the cylinder head sub-assembly on wooden blocks.
| *a | Wooden Block |
Using SST, remove the valve spring retainer lock, valve spring retainer and inner compression spring.
Arrange the removed parts for each cylinder in the correct order.
Remove the intake valve.
Arrange the removed parts for each cylinder in the correct order.
2.REMOVE EXHAUST VALVE
| *a | Wooden Block |
Using SST, remove the valve spring retainer lock, valve spring retainer and inner compression spring.
Arrange the removed parts for each cylinder in the correct order.
Remove the exhaust valve.
Arrange the removed parts for each cylinder in the correct order.
13711E
3.REMOVE VALVE STEM OIL SEAL
Using needle-nose pliers, remove the valve stem oil seals.
13734
4.REMOVE VALVE SPRING SEAT
Using compressed air and a magnet hand, remove the valve spring seats by blowing air onto them.