13734
1.INSTALL VALVE SPRING SEAT
Install the 12 valve spring seats to the cylinder head sub-assembly.
13711E
2.INSTALL VALVE STEM OIL SEAL
| *a | Intake Side |
| *b | Exhaust Side |
| *c | Green or Gray |
| *d | Brown or Black |
Apply a light coat of engine oil to 12 new valve stem oil seals.
Pay close attention when installing the intake valve stem oil seal or exhaust valve stem oil seal. For example, installing the intake valve stem oil seal to the exhaust side or installing the exhaust valve stem oil seal to the intake side can cause installation problems later.
for Intake Side
The intake side valve stem oil seals is green or gray.
for Exhaust Side
The exhaust side valve stem oil seals is brown or black.
Using SST, push in the 12 valve stem oil seals.
Failure to use SST will cause the valve stem oil seal to be damaged or improperly seated.
| *a | Intake Side |
| *b | Exhaust Side |
| *c | Depth |
Make sure that each valve stem oil seal is pushed in to the specified depth as shown in the illustration.
9.7 to 11.3 mm (0.382 to 0.445 in.)
9.3 to 10.9 mm (0.366 to 0.429 in.)
3.INSTALL INTAKE VALVE
Place the cylinder head sub-assembly on wooden blocks.
| *a | Application Width |
Apply engine oil to the tip area of the intake valve as shown in the illustration.
30 mm (1.18 in.) or more
Install the intake valve, inner compression spring and valve spring retainer to the cylinder head sub-assembly.
Install the same parts in the same combination to their original locations.
| *a | Wooden Block |
Using SST, compress the inner compression spring and install the valve spring retainer lock.
| *a | Wooden Block |
Using a pin punch, gently tap the valve stem tip to ensure that it is fitted properly.
Be careful not to damage the intake valve stem tip.
Be careful not to damage the valve spring retainer.
4.INSTALL EXHAUST VALVE
| *a | Application Width |
Apply engine oil to the tip area of the exhaust valve as shown in the illustration.
30 mm (1.18 in.) or more
Install the exhaust valve, inner compression spring and valve spring retainer to the cylinder head sub-assembly.
Install the same parts in the same combination to their original locations.
| *a | Wooden Block |
Using SST, compress the inner compression spring and install the valve spring retainer lock.
| *a | Wooden Block |
Using a pin punch, gently tap the valve stem tip to ensure that it is fitted properly.
Be careful not to damage the exhaust valve stem tip.
Be careful not to damage the valve spring retainer.
5.APPLY ENGINE OIL
| *a | Apply engine oil |
Apply engine oil to the top surfaces of the valves as shown in the illustration.