1.REPLACE RING PIN
It is not necessary to remove the ring pins unless they are being replaced.
| *a | Upper Side |
| *b | Width |
| *c | Height |
| *d | Protrusion Height |
Using a plastic hammer, tap in the 2 ring pins.
6.0 to 7.0 mm (0.236 to 0.276 in.)
| Item | Height | Width | Protrusion Height |
|---|---|---|---|
| Ring Pin | 11.7 to 12.3 mm (0.461 to 0.484 in.) | 12.0 mm (0.472 in.) | 6.0 to 7.0 mm (0.236 to 0.276 in.) |
2.REPLACE STRAIGHT PIN
It is not necessary to remove the straight pins unless they are being replaced.
Using a plastic hammer, tap in the 6 straight pins.
| *a | Front Side | *b | Rear Side |
| *c | Width | *d | Height |
| *e | Protrusion Height | - | - |
| Item | Height | Width | Protrusion Height |
|---|---|---|---|
| Pin (A) | 14.0 mm (0.551 in.) | 6.0 mm (0.236 in.) | 7.0 to 8.0 mm (0.276 to 0.315 in.) |
| Pin (B) | 15.0 mm (0.591 in.) | 10.0 mm (0.394 in.) | 8.0 to 9.0 mm (0.315 to 0.354 in.) |