Home › Engine / Hybrid System › 1KR-FE (COOLING) › COOLING SYSTEM › from 2020.07
RM36W0E _51 Engine / Hybrid System _091037 1KR-FE COOLING _0431354 COOLING SYSTEM G

1KR-FE COOLING  COOLING SYSTEM  ON-VEHICLE INSPECTION  


CAUTION / NOTICE / HINT

CAUTION:
A450951

Do not remove the radiator cap sub-assembly while the engine and radiator assembly are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.


PROCEDURE

Hide 1.INSPECT FOR COOLANT LEAK

CAUTION:

Do not remove the radiator cap sub-assembly while the engine and radiator assembly are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.


a.

Remove the radiator cap sub-assembly.


b.
A450952C01
2.5,0.76 2.833,0.219 true 2.833,0.094 3.073,0.292 0.24,0.198 10 true *1
*1 Radiator Cap Tester


Fill the radiator assembly with engine coolant, and then install a radiator cap tester.


c.

Warm up the engine.


d.

Pump the radiator cap tester to 123 kPa (1.3 kgf/cm2, 18 psi), and then check that the pressure does not drop.

·

If the pressure drops, check the hoses, radiator assembly and water pump assembly (water inlet housing) for leaks.

·

If there are no signs of external engine coolant leaks, check the heater core, cylinder block sub-assembly and cylinder head sub-assembly.



e.

Remove the radiator cap tester.


f.

Install the radiator cap sub-assembly.


Hide 2.INSPECT RESERVOIR TANK ENGINE COOLANT LEVEL

A450953C04
1.385,1.708 2.76,1.479 true 2.167,1.115 2.781,1.01 true 2.854,0.885 3.167,1.042 0.313,0.156 10 false *a 2.844,1.375 3.156,1.531 0.313,0.156 10 false *b
*a FULL Line
*b LOW Line


a.

Check that the engine coolant level is between the low line and full line when the engine is cold.

If the engine coolant level is low, check for leaks and add engine coolant to the full line.

NOTICE:

Do not substitute plain water for engine coolant.



Hide 3.INSPECT ENGINE COOLANT QUALITY

CAUTION:

Do not remove the radiator cap sub-assembly while the engine and radiator assembly are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.


a.

Remove the radiator cap sub-assembly.


b.

Check if there are any excessive deposits of rust or scale around the radiator cap sub-assembly and water filler hole. Also, the engine coolant should be free of oil.

If excessively dirty, replace the engine coolant.


c.

Install the radiator cap sub-assembly.