11101J
1.INSPECT CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 1 - 2 | 20°C (68°F) | 6.9 to 7.9 Ω |
If the result is not as specified, replace the camshaft timing oil control valve assembly.
Check the operation.
| *a | Component without harness connected
(Camshaft Timing Oil Control Valve Assembly) |
| *b | When Applied |
| *c | When Cut Off |
| *d | Spool Valve |
Connect a battery positive (+) lead to terminal 1 and negative (-) lead to terminal 2, and check the movement of the spool valve.
| Condition | Specified Condition |
|---|---|
| Battery voltage applied | Valve moves in left arrow direction shown in illustration |
| Battery voltage cut off | Valve moves in right arrow direction shown in illustration |
Accumulation of foreign matter can cause minor pressure leaks. Minor pressure leaks will cause the camshaft to advance or retard, and this will cause a DTC to be stored.
If the result is not as specified, replace the camshaft timing oil control valve assembly.