Home › Engine / Hybrid System › 1KR-FE (ENGINE CONTROL) › CAMSHAFT OIL CONTROL VALVE › from 2020.07
RM36W0E _51 Engine / Hybrid System _091054 1KR-FE ENGINE CONTROL _0431469 CAMSHAFT OIL CONTROL VALVE G

1KR-FE ENGINE CONTROL  CAMSHAFT OIL CONTROL VALVE  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 11101J 1.INSPECT CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY

a.

Connect the GTS to the DLC3.


b.

Start the engine.


c.

Turn the GTS on.


d.

Turn the A/C switch on.


e.

Inspect the camshaft timing oil control valve assembly (for intake side).

i.

Enter the following menus: Powertrain / Engine / Active Test / Control the Intake VVT OCV Duty Ratio Bank1.

Powertrain > Engine > Active Test
Tester Display
Control the Intake VVT OCV Duty Ratio Bank 1
50004 372 4

ii.

Check the engine speed while operating the camshaft timing oil control valve assembly using the GTS.

Standard Condition:
GTS Operation Specified Condition
0% Normal engine speed
100% Engine idles roughly or stalls


HINT:
·

If the result is not as specified, allow the engine to cool (engine coolant temperature of 50°C (122°F) or less) and perform the Active Test again.

·

DTCs related to the VVT system may be stored due to Active Test operation, but this does not indicate a malfunction.



If the operation is not as specified, check the camshaft timing oil control valve assembly, wire harness and ECM.



f.

Inspect the camshaft timing oil control valve assembly (for exhaust side).

i.

Enter the following menus: Powertrain / Engine / Active Test / Control the Exhaust VVT OCV Duty Ratio Bank1.

Powertrain > Engine > Active Test
Tester Display
Control the Exhaust VVT OCV Duty Ratio Bank 1
50004 372 5

ii.

Check the engine speed while operating the camshaft timing oil control valve assembly using the GTS.

Standard Condition:
GTS Operation Specified Condition
0% Normal engine speed
100% Engine idles roughly or stalls


HINT:
·

If the result is not as specified, allow the engine to cool (engine coolant temperature of 50°C (122°F) or less) and perform the Active Test again.

·

DTCs related to the VVT system may be stored due to Active Test operation, but this does not indicate a malfunction.



If the operation is not as specified, check the camshaft timing oil control valve assembly, wire harness and ECM.