Home › Engine / Hybrid System › 1KR-FE (ENGINE CONTROL) › CAMSHAFT POSITION SENSOR › from 2020.07
RM36W0E _51 Engine / Hybrid System _091054 1KR-FE ENGINE CONTROL _0431473 CAMSHAFT POSITION SENSOR A

1KR-FE ENGINE CONTROL  CAMSHAFT POSITION SENSOR  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.REMOVE AUXILIARY BATTERY

Hide 11101E 3.REMOVE CAMSHAFT POSITION SENSOR (for Intake Side)

a.
A425366

Disconnect the camshaft position sensor connector.


b.

Remove the bolt and camshaft position sensor from the cylinder head sub-assembly.

NOTICE:

If the camshaft position sensor has been struck or dropped, replace it.



Hide 11101E 4.REMOVE CAMSHAFT POSITION SENSOR (for Exhaust Side)

a.
A468337

Disconnect the camshaft position sensor connector.


b.

Remove the bolt and camshaft position sensor from the cylinder head cover sub-assembly.

NOTICE:

If the camshaft position sensor has been struck or dropped, replace it.