Home › Engine / Hybrid System › 1KR-FE (ENGINE CONTROL) › CRANKSHAFT POSITION SENSOR › from 2020.07
RM36W0E _51 Engine / Hybrid System _091054 1KR-FE ENGINE CONTROL _0431474 CRANKSHAFT POSITION SENSOR A

1KR-FE ENGINE CONTROL  CRANKSHAFT POSITION SENSOR  INSTALLATION  


PROCEDURE

Hide 11301K 1.INSTALL CRANKSHAFT POSITION SENSOR

a.
A323865

Apply a light coat of engine oil to the O-ring of the crankshaft position sensor.

NOTICE:

If reusing the crankshaft position sensor, be sure to inspect the O-ring.



b.

Install the crankshaft position sensor to the timing chain cover sub-assembly with the bolt.

Torque:
7.5 N*m (76 kgf*cm, 66 in.*lbf)

NOTICE:
·

If the crankshaft position sensor has been struck or dropped, replace it.

·

Make sure that the O-ring is not cracked or moved out of place during installation.




c.

Connect the crankshaft position sensor connector.