Home › General › SPECIFICATIONS › 1KR-FE ENGINE CONTROL › from 2020.07
RM36W0E _V1 General _087262 SPECIFICATIONS _0431466 1KR-FE ENGINE CONTROL F

SPECIFICATIONS  1KR-FE ENGINE CONTROL  SERVICE DATA  


SPARK PLUG
Standard Insulation Resistance Spark plug (terminal part) - Body ground 10 MΩ or higher
Spark Plug Type DENSO made FC16HR-Q8
Maximum Electrode Gap for Used Spark Plug 1.1 mm (0.0433 in.)
Standard Electrode Gap for New Spark Plug 0.7 to 0.8 mm (0.0276 to 0.0315 in.)

CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY
Standard Resistance 20°C (68°F) 6.9 to 7.9 Ω

THROTTLE BODY WITH MOTOR ASSEMBLY
Standard Throttle Valve Opening Percentage Shift lever in N 60% or higher
Standard Resistance 5 (M-) - 6 (M+) 20°C (68°F) 0.3 to 100 Ω

ACCELERATOR PEDAL SENSOR ASSEMBLY
Standard Percentage (Accel Sens. No.1 Volt %) Accelerator pedal fully released 10 to 25%
Accelerator pedal fully depressed 50 to 100%
Standard Percentage (Accel Sens. No.2 Volt %) Accelerator pedal fully released 20 to 45%
Accelerator pedal fully depressed 68 to 100%

CRANKSHAFT POSITION SENSOR
Standard Resistance Cold 1630 to 2740 Ω
Hot 2065 to 3225 Ω

ENGINE COOLANT TEMPERATURE SENSOR
Standard Resistance 20°C (68°F) 2.32 to 2.59 kΩ
80°C (176°F) 0.310 to 0.326 kΩ

HEATED OXYGEN SENSOR (for Sensor 1)
Standard Resistance 1 (+B) - 2 (HT1A) 20°C (68°F) 2.7 to 3.3 Ω
2 (HT1A) - 3 (E1) Always 10 kΩ or higher

HEATED OXYGEN SENSOR (for Sensor 2)
Standard Resistance 1 (+B) - 2 (HT1B) 20°C (68°F) 2.7 to 3.3 Ω
2 (HT1B) - 3 (E1) Always 10 kΩ or higher

IG2 RELAY (IG2)
Standard Resistance 3 - 5 Battery voltage not applied between terminals 1 and 2 10 kΩ or higher
Battery voltage applied between terminals 1 and 2 Below 1 Ω