Home › Engine / Hybrid System › 1KR-FE (ENGINE CONTROL) › SFI SYSTEM › from 2020.07
RM36W0E _51 Engine / Hybrid System _091054 1KR-FE ENGINE CONTROL _0431746 SFI SYSTEM U

1KR-FE ENGINE CONTROL  SFI SYSTEM  FAIL-SAFE CHART  


If any of the following DTCs are stored, the ECM enters fail-safe mode to allow the vehicle to be driven temporarily or stops fuel injection.

DTC No. Component Fail-Safe Operation Fail-Safe Deactivation Condition
P055512
P055514
P05552A
Vacuum sensor assembly The frequency that the air conditioning system is turned off is increased. Pass condition detected
P011011
P011015
Intake air temperature sensor ECM estimates intake air temperature to be 20°C (68°F) Pass condition detected
P011511
P011515
P01152A
Engine coolant temperature sensor ECM performs engine control using estimated engine coolant temperature calculated from intake air temperature at time of engine start and intake air volume Pass condition detected
P012011
P012015
P01201C
P022011
P022015
P02201C
Throttle Position sensor ECM limits its accelerator pedal position sensor value to below 40% Pass condition detected and ignition switch off
P030100
P030200
P030300
Misfire detected If misfire rate of cylinder exceeds catalytic damage misfire rate, fuel supply to that cylinder is suspended Pass condition detected and ignition switch off
P032511
P032515
Knock control sensor ECM sets ignition timing to maximum retard Pass condition detected
P033525
P03352A
Crank position sensor
·

Maximum engine speed limited to 3000 rpm

·

Idle speed raised to 1000 rpm


Pass condition detected
P040000
P040311
P040312
P040313
EGR valve assembly ECM assumes that EGR valve is closed, so that ignition angle is controlled with safety valve Pass condition detected
P012011
P012015
P01201C
P022011
P022015
P02201C
P060444
P060612
P060649
P060A1C*1
P060A49*1
P060E87
P065714
P06579E
P210018
P210019
P210064
P210900
P210956
P211172
P211819
P211977
Throttle control system Power source of throttle control motor shuts down, and engine speed is limited by fuel cut.
However, if DTC P211172 (Throttle Actuator "A" Control System Actuator Stuck Open) is stored, engine speed will be limited to 0 rpm and engine will stop.
Pass condition detected and ignition switch off
P060A49*2
P060A1C*2
P212012
P212014
P212512
P212514
P21382B
Accelerator pedal position sensor ECM limits its accelerator pedal position sensor value below 40% Pass condition detected and ignition switch off
P060D49
P212012
P212014
P212512
P212514
Accelerator pedal position sensor Drive with "fast idle" condition Pass condition detected and ignition switch off
P244B00
P246300
Gasoline particulate filter system Output power is limited. Ignition switch off

HINT:
·

*1: When the throttle monitoring CPU of the ECM is malfunctioning.

·

*2: When the accelerator pedal position monitoring CPU of the ECM is malfunctioning.