Home › Engine / Hybrid System › 1KR-FE (ENGINE CONTROL) › SFI SYSTEM › from 2020.07
RM36W0E _51 Engine / Hybrid System _091054 1KR-FE ENGINE CONTROL _0431746 SFI SYSTEM C

1KR-FE ENGINE CONTROL  SFI SYSTEM  U012987  Lost Communication With Brake System Control Module Missing Message  U110387  Lost Communication with Stop and Start Control Module Missing Message  


DESCRIPTION

The ECM, brake actuator assembly (skid control ECU assembly) and engine stop and start ECU* communicate with each other via CAN communication. Each ECUs also communicate with other computers through the ECM. If there is a problem with this communication, the ECM stores this DTC.

*: w/ Stop and Start System

DTC No. Detection Item DTC Detection Condition Trouble Area MIL Memory DTC Output from Priority
U012987 Lost Communication With Brake System Control Module Missing Message All of the following conditions are met for 0.7 seconds (1 trip detection logic):
·

Ignition switch ON

·

Battery voltage 10 V or higher

·

No communication between ECM and skid control ECU


·

Brake actuator assembly (Skid control ECU assembly)

·

CAN communication system

·

ECM


Comes on DTC stored Engine B
U110387 Lost Communication with Stop and Start Control Module Missing Message Both of the following conditions are met for 0.76 seconds (1 trip detection logic):
·

Ignition switch ON

·

Battery voltage 10 V or higher

·

No communication between ECM and stop and start ECU


·

Wire harness (CANL and CANH circuits)

·

ECM

·

Engine stop and start ECU


- DTC stored (w/ stop and start system)
- (w/o stop and start system)
Engine B

CONFIRMATION DRIVING PATTERN

·

DTC U012987 is detected when the ignition switch is ON and wait for 3 seconds.

·

DTC U110387 is detected when the ignition switch is ON and wait for 2 seconds.


CAUTION / NOTICE / HINT

HINT:
·

When DTCs indicating a CAN communication system malfunction are output, repair the CAN communication system first.

·

Read freeze frame data using the GTS. The ECM records vehicle and driving condition information as freeze frame data the moment a DTC is stored. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, if the air-fuel ratio was lean or rich, and other data from the time the malfunction occurred.

·

If the CAN communication system is malfunctioning, there is no data output from the ECM. In this case, some of the freeze frame data will not be correct and not identical with the ECM data, but the ECM data are correct.



PROCEDURE

1.CHECK ANY OTHER DTCS OUTPUT (IN ADDITION TO DTC U012987 OR U110387)
a.

Enter the following menus: System Select / Health Check.


b.

Read the DTCs.

Result:
Result Proceed to
DTC U012987 or U110387 and other DTCs are output A
DTC U012987 or U110387 is output B




A

GO TO DTC CHART

B