84040
1.INSPECT MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY (for LHD)
| *a | Component without harness connected
(Multiplex Network Master Switch Assembly) |
Check the resistance.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| L13-20 (UP) - L13-12 (GND) | Up position | Below 100 Ω |
| L13-15 (DOWN) - L13-12 (GND) | Down position | Below 100 Ω |
If the result is not as specified, replace the multiplex network master switch assembly.
Check that the LED illuminates.
| *a | Component without harness connected
(Multiplex Network Master Switch Assembly) |
Apply auxiliary battery voltage to the multiplex network master switch assembly and check that the LED illuminate.
| Battery Connection | Specified Condition |
|---|---|
| Auxiliary battery positive (+) → L13-3 (ILL+)
Auxiliary battery negative (-) → L13-13 (ILL-) |
LED illuminate |
If the result is not as specified, replace the multiplex network master switch assembly.
84040
2.INSPECT MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY (for RHD)
| *a | Component without harness connected
(Multiplex Network Master Switch Assembly) |
Check the resistance.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| K5-20 (UP) - K5-12 (GND) | Up position | Below 100 Ω |
| K5-15 (DOWN) - K5-12 (GND) | Down position | Below 100 Ω |
If the result is not as specified, replace the multiplex network master switch assembly.
Check that the LED illuminates.
| *a | Component without harness connected
(Multiplex Network Master Switch Assembly) |
Apply auxiliary battery voltage to the multiplex network master switch assembly and check that the LED illuminate.
| Battery Connection | Specified Condition |
|---|---|
| Auxiliary battery positive (+) → K5-3 (ILL+)
Auxiliary battery negative (-) → K5-13 (ILL-) |
LED illuminate |
If the result is not as specified, replace the multiplex network master switch assembly.