Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
87961
1.REMOVE OUTER MIRROR
Apply protective tape to the area as shown in the illustration.
Push the upper part of the mirror surface and tilt it.
Do not push the outer mirror with excessive force. Doing so may cause the actuator to come off or break the mirror surface.
Using a moulding remover D, disengage the claws on the lower part of the outer mirror.
If excessive force is used when pressing down the mirror surface, the claws will engage again.
| *A | for TMC Made | *B | for TMMF Made |
Push the lower part of the mirror surface and tilt it.
Do not push the outer mirror with excessive force. Doing so may cause the actuator to come off or break the mirror surface.
If excessive force is used when pressing down the mirror surface, the claws will engage again.
Using a moulding remover A, disengage the claws on the upper part of the outer mirror.
| *A | for TMC Made | *B | for TMMF Made |
w/ Blind Spot Monitor System:
Disconnect the connector.
| *A | for TMC Made | *B | for TMMF Made |
w/ Mirror Heater:
Disconnect the 2 connectors.
| *A | for TMC Made | *B | for TMMF Made |