Use the same procedure for RHD and LHD vehicles.
The procedure below is for LHD vehicles.
85292B
1.REMOVE FRONT WIPER ARM HEAD CAP
| *a | Protective Tape |
|
Remove in this Direction |
Using a screwdriver with its tip wrapped with protective tape, disengage the claws to remove the front wiper arm head cap.
Use the same procedure for the RH side and LH side.
2.REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY LH
Remove the nut and front wiper arm and blade assembly LH.
3.REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY RH
Remove the nut and front wiper arm and blade assembly RH.
53867
4.REMOVE FRONT FENDER TO COWL SIDE SEAL LH
Disengage the claws and guide.
|
Remove in this Direction |
Disengage the guides to remove the front fender to cowl side seal LH as shown in the illustration.
53866
5.REMOVE FRONT FENDER TO COWL SIDE SEAL RH
Use the same procedure as for the LH side.
55708
6.REMOVE COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY
Remove the 2 clips.
|
Remove in this Direction | - | - |
Disconnect the washer hose.
Disengage the claws and guides to remove the cowl top ventilator louver sub-assembly as shown in the illustration.
7.REMOVE WINDSHIELD WIPER MOTOR AND LINK
Remove the 2 bolts.
| *a | Motor Grommet |
|
Remove in this Direction |
Disengage the motor grommet as shown in the illustration.
Be careful not to damage the windshield glass when removing the windshield wiper motor and link.
Disconnect the connector to remove the windshield wiper motor and link.
85110
8.REMOVE WINDSHIELD WIPER MOTOR ASSEMBLY
| *1 | No. 1 Windshield Wiper Link Rod |
| *a | Protective Tape |
| *b | Pivot of Windshield Wiper Motor Assembly |
Using a screwdriver with its tip wrapped in protective tape, separate the No. 1 windshield wiper link rod from the pivot of the windshield wiper motor assembly as shown in the illustration.
for LHD:
Remove the 3 bolts.
|
Remove in this Direction (1) |
|
Remove in this Direction (2) |
Move the windshield wiper motor assembly in the direction indicated by the arrow (1), then pull the windshield wiper motor assembly in the direction indicated by the arrow (2) shown in the illustration to remove it from the wiper link assembly.
for RHD:
Using a T30 "TORX" socket wrench, remove the 2 screws.
Disengage the guides to remove the windshield wiper motor assembly.
85112A
9.REMOVE NO. 1 WINDSHIELD WIPER SHAFT COVER
Disengage the claw and guide to remove the no. 1 windshield wiper shaft cover.