Use the same procedure for TMC Made and TMMF Made vehicles.
The procedure below is for TMMF Made vehicles.
45287
1.REMOVE LOWER STEERING COLUMN COVER
Removing the lower steering column cover in the incorrect order will cause the parts to break.
Release the tilt and telescopic lever and fully extend and lower the steering column assembly.
Lock the tilt and telescopic lever.
Turn the steering wheel assembly to the left and remove the screw.
Turn the steering wheel assembly to the right and remove the screw.
Remove the screw.
|
Push |
Disengage the claws to remove the lower steering column cover as shown in the illustration.
45286B
2.REMOVE UPPER STEERING COLUMN COVER
Disengage the claw to remove the upper steering column cover.
84650
3.REMOVE WINDSHIELD WIPER SWITCH ASSEMBLY
Turn the steering wheel assembly to the left.
| *a | Protective Tape |
|
Remove in this Direction |
Using a screwdriver with its tip wrapped in protective tape, disengage the claw to remove the windshield wiper switch assembly as shown in the illustration.
If the claw is pulled with excessive force, it may break.