Home › Vehicle Exterior › WIPER / WASHER › RAIN SENSOR › from 2020.07
RM36W0E _59 Vehicle Exterior _088063 WIPER / WASHER _0431810 RAIN SENSOR A

WIPER / WASHER  RAIN SENSOR  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for RHD and LHD vehicles.

·

The procedure below is for LHD vehicles.



PROCEDURE

Hide 89944 1.INSTALL RAIN SENSOR TAPE

HINT:
·

Only perform this procedure when replacing the rain sensor tape.

·

Replace the rain sensor tape with new one if it is damaged or contaminated.



a.

Clean the sensing portion of the rain sensor with a piece of cloth.


b.
E358291N01
1.167,0.188 1.323,0.385 0.156,0.198 10 false A 0.292,0.833 0.448,1.031 0.156,0.198 10 false B

Peel off the smaller release sheet, and then attach the rain sensor tape to the sensing portion of the rain sensor as shown in the illustration.

Standard Clearance
Measurement Area Measurement
A 21.8 mm (0.858 in.)
B 7.25 mm (0.285 in.)

HINT:

Use your fingers to push out any air bubbles from under the tape.



Hide 89941 2.INSTALL RAIN SENSOR

a.

Clean the windshield glass with a piece of cloth.

NOTICE:
·

Make sure that there is no rain sensor tape residue from the removed rain sensor on the windshield glass. If there is, remove the residue.

·

If there is any rain sensor tape residue remaining on the windshield glass, replace the tape.

·

If the rain sensor has been dropped, replace it with a new one.




b.

When installing a new rain sensor or when the rain sensor tape has been replaced:

i.

Remove the peeling paper.

HINT:

Do not directly touch the rain sensor tape surface.




c.

Connect the connector.


d.
E433292C02
0.854,1.885 0.969,1.646 false 0.719,1.875 1.031,2.073 0.313,0.198 10 false *a
*a Stopper
V100135

Push
V113147

Install in this Direction


Gradually attach the rain sensor to the windshield glass surface as shown in the illustration to prevent air bubbles from forming between them.

HINT:

Do not touch the rain sensor tape surface or windshield glass surface.



e.

Push in the stopper to install the rain sensor as shown in the illustration.


Hide 89943 3.INSTALL RAIN SENSOR COVER

a.
E433289

Engage the claws and guide to install the rain sensor cover.