Home › Brake › BRAKE (REAR) › REAR BRAKE (for TMMF Made) › 2020.07–2021.11
RM36W0E _54 Brake _089429 BRAKE (REAR) _0432132 REAR BRAKE(for TMMF Made) G

BRAKE (REAR)  REAR BRAKE(for TMMF Made)  INSPECTION  


PROCEDURE

Hide 1.INSPECT REAR BRAKE DRUM INSIDE DIAMETER

a.
F006408C04
2.208,0.292 2.094,0.698 false 2.229,0.177 2.385,0.333 0.156,0.156 10 false *a
*a Brake Drum Gauge


Using a brake drum gauge or an equivalent tool, measure the inside diameter of the rear brake drum.

Inside diameter:
Standard Maximum
202.5 mm (7.972 in.) 204 mm (8.032 in.)


If the inside diameter is greater than the maximum, replace the rear brake drum sub-assembly.


Hide 2.INSPECT REAR BRAKE SHOE LINING THICKNESS

a.
F042690C02
2.948,0.271 2.813,0.604 true 2.969,0.156 3.125,0.313 0.156,0.156 10 false *a
*a Ruler


Using a ruler, measure the thickness of the shoe lining.

Thickness:
Standard Minimum
4.2 mm (0.165 in.) 1.0 mm (0.039 in.)


If the lining thickness is equal to or less than the minimum value, or if there is any severe or uneven wear, replace the rear brake shoe assembly.

NOTICE:

If the brake shoes need replacing, they must be replaced as a set.



Hide 3.INSPECT REAR BRAKE DRUM AND REAR BRAKE SHOE LINING FOR PROPER CONTACT

a.
C151738

Apply chalk to the inside surface of the rear brake drum sub-assembly, then grind the brake shoe lining so that they fit together properly.

If the contact between the rear brake drum sub-assembly and the shoe lining is improper, repair it using a brake shoe grinder or replace the rear brake shoe assembly.


Hide 4.INSPECT REAR WHEEL BRAKE CYLINDER

a.

Check the cylinder bore and piston for rust and scoring.