Home › Engine / Hybrid System › HYBRID / BATTERY CONTROL › WATER PUMP WITH MOTOR › from 2020.07
RM36W0E _51 Engine / Hybrid System _087936 HYBRID / BATTERY CONTROL _0424588 WATER PUMP WITH MOTOR A

HYBRID / BATTERY CONTROL  WATER PUMP WITH MOTOR  REMOVAL  


PROCEDURE

Hide 51451A 1.REMOVE CENTER ENGINE UNDER COVER (w/ Cover)

Hide G9040 3.REMOVE INVERTER WATER PUMP ASSEMBLY

a.
A464200

Disconnect the inverter water pump assembly connector.

NOTICE:
To prevent coolant from entering the inverter water pump assembly connector, perform the following procedure.

Apply insulating tape to the connectors of the wire harness and inverter water pump assembly.



b.

Remove the 2 bolts.


c.
A464201C01
1.229,0.5 1.563,0.5 true 2.49,0.625 2.74,0.25 true 1,0.396 1.208,0.573 0.208,0.177 10 true *1 2.74,0.135 2.958,0.333 0.219,0.198 10 true *2
*1 Outlet No. 1 Hybrid Water Pump Hose
*2 Inlet Hybrid Water Pump Hose


Slide the 2 clips and disconnect the outlet No. 1 hybrid water pump hose and inlet hybrid water pump hose to remove the inverter water pump assembly.

NOTICE:
·

Put pieces of cloth into the pipes and disconnected hoses or cover the pipes and hoses with plastic bags to prevent foreign matter from entering the inverter water pump assembly and inverter cooling system.

·

Do not apply excessive force to the hoses.