Home › General › SPECIFICATIONS › 1KR-FE STARTING › from 2020.07
RM36W0E _V1 General _087262 SPECIFICATIONS _0432153 1KR-FE STARTING F

SPECIFICATIONS  1KR-FE STARTING  SERVICE DATA  


Starter Assembly (w/ Stop And Start System)
Tester Connection Condition Specified Condition
Battery positive (+) terminal - Terminal 30 - Terminal 50 11.5 V Below 90 A

Starter Assembly (w/o Stop And Start System)
Tester Connection Condition Specified Condition
Battery positive (+) terminal - Terminal 30 - Terminal 50 11.5 V Below 90 A

Magnet start switch assembly
Tester Connection Condition Specified Condition
Terminal 50 - Terminal C Always Below 1 Ω
Terminal 50 - Magnet starter switch assembly body Always Below 2 Ω

Starter Armature Assembly (w/ Stop And Start System)
Tester Connection Condition Specified Condition
Segment - Segment Always Below 1 Ω
Segment - Starter armature core 10 kΩ or higher

Commutator runout Maximum runout 0.4 mm (0.0157 in.)

Commutator diameter Standard diameter 28.0 mm (1.1024 in.)
Minimum diameter 27.0 mm (1.0630 in.)

Undercut depth Standard undercut depth 0.6 mm (0.0236 in.)
Minimum undercut depth 0.2 mm (0.0079 in.)

Starter Armature Assembly (w/o Stop And Start System)
Tester Connection Condition Specified Condition
Segment - Segment Always Below 1 Ω
Segment - Starter armature core 10 kΩ or higher

Commutator runout Maximum runout 0.4 mm (0.0157 in.)

Commutator diameter Standard diameter 28.0 mm (1.1024 in.)
Minimum diameter 27.0 mm (1.0630 in.)

Undercut depth Standard undercut depth 0.6 mm (0.0236 in.)
Minimum undercut depth 0.2 mm (0.00787 in.)

Starter Yoke Assembly
Tester Connection Condition Specified Condition
Terminal C - Brush leads (+) Always Below 1 Ω
Starter yoke - Brush leads (-) Starter yoke - Brush leads (-) Below 1 Ω
Brush length Standard length 10 mm (0.3937 in.)
Minimum length 6 mm (0.2362 in.)

Engine Switch
Tester Connection Condition Specified Condition
H68-12(SS1) - H68-3(GND)
H68-6(SS2) - H68-3(GND)
H68-11(SS3) - H68-3(GND)
Not pushed 10 kΩ or higher
Pushed Below 1 Ω

Tester Connection Condition Specified Condition
H68-5(SWIL) - H68-3(GND) H68-5(SWIL) - Auxiliary battery positive (+)
H68-3(GND) - Auxiliary battery negative (-)
Illuminates

Ignition or Starter Switch Assembly
Tester Connection Condition Specified Condition
Between all terminals LOCK 10 kΩ or higher
H54-6 (ACC) - H54-7 (AM1) ACC Below 1 Ω
H54-6 (ACC) - H54-7 (AM1) - H54-8 (IG1) ON Below 1 Ω
H54-1 (AM2) - H54-2 (IG2)
H54-5 (ST1) - H54-7 (AM1) - H54-8 (IG1) START Below 1 Ω
H54-1 (AM2) - H54-2 (IG2) - H54-4 (ST2)

ST No. 1 Relay
Tester Connection Condition Specified Condition
3 - 5 Battery voltage not applied to terminals 1 and 2 10 kΩ or higher
Battery voltage applied to terminals 1 and 2 Below 1 Ω