Home › Engine / Hybrid System › M15A-FKS (STARTING) › STARTER (w/ Stop And Start System) › from 2020.07
RM36W0E _51 Engine / Hybrid System _089409 M15A-FKS STARTING _0432160 STARTER(w/ Stop And Start System) A

M15A-FKS STARTING  STARTER(w/ Stop And Start System)  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during starter assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Auxiliary battery terminal is disconnected/reconnected Memorize steering angle neutral point Parking assist monitor system (Click here)

HINT:

When the cable is disconnected / reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.

·

Learning completes when vehicle is driven

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Lane tracing assist system Drive the vehicle straight ahead at 35 km/h (22 mph) or more for 5 seconds or more. (Click here)
Pre-collision system
Stop and start system Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes) (Click here)

·

Learning completes when vehicle is operated normally

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Power door lock control system
·

Back door opener


Perform door unlock operation with door control switch or electrical key transmitter sub-assembly switch. (Click here)
Air conditioning system After the ignition switch is turned to ON, the servo motor standard position is recognized. -



PROCEDURE

Hide 1. PRECAUTION

NOTICE:
·

After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal.

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>BEFORE DISCONNECTING BATTERY

·

When the starter assembly is replaced, "ST NO. 1 relay" and "ST NO. 2 relay" must also be replaced.



Hide 2.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

Hide 3.REMOVE AIR CLEANER ASSEMBLY WITH AIR CLEANER HOSE

a.

Disconnect the connector.

A461159


b.

Disconnect the clamp.


c.

Slide the clip and disconnect the No. 2 ventilation hose from the cylinder head cover sub-assembly.


d.

Loosen the hose clamp and remove the air cleaner hose from the throttle body assembly.


e.

Disengage the 3 grommets to remove the air cleaner assembly with air cleaner hose from the vehicle body.


Hide 11363A 4.REMOVE FLYWHEEL HOUSING SIDE COVER

a.
A464206

Detach the claw as shown in the illustration to remove the flywheel housing side cover.


Hide 28100 5.REMOVE STARTER ASSEMBLY

a.

Disengage the 3 clamps to separate the No. 4 water by-pass hose and engine wire from the bracket.

A461629


b.
A469405

Disconnect the 2 starter assembly connectors.


c.

Open the terminal cap.


d.
A469406

Remove the nut and disconnect the engine wire from terminal 30.


e.
A469407

Remove the 2 bolts and starter assembly from the cylinder block sub-assembly.