Home › Drivetrain › C551 (MANUAL TRANSMISSION / TRANSAXLE) › DIFFERENTIAL CASE › from 2020.07
RM36W0E _52 Drivetrain _091208 C551 MANUAL TRANSMISSION / TRANSAXLE _0432177 DIFFERENTIAL CASE G

C551 MANUAL TRANSMISSION / TRANSAXLE  DIFFERENTIAL CASE  INSPECTION  


PROCEDURE

Hide 1.INSPECT FRONT DIFFERENTIAL SIDE GEAR BACKLASH

a.
G021412

Using a dial indicator, measure the front differential side gear backlash.

Standard backlash:

0.10 to 0.15 mm (0.00394 to 0.00591 in.)


If the backlash is not as specified, replace the front differential side gear thrust washers with washers of a different thickness. Use the table below to select a front differential side gear thrust washer which will ensure that the backlash is within the specification.

Thrust Washer Thickness:
Part No. Thickness
mm (in.)
41361-70010 0.500 (0.0197)
41361-70020 0.550 (0.0217)
41361-70030 0.600 (0.0236)
41361-70040 0.650 (0.0256)
41361-70050 0.700 (0.0276)
41361-70060 0.750 (0.0295)
41361-70070 0.800 (0.0315)
41361-70080 0.850 (0.0335)
41361-70090 0.900 (0.0354)
41361-70100 0.950 (0.0374)


HINT:

Select washers of the same thickness for both the right and left sides.



Hide 41351F 2.INSPECT FRONT DIFFERENTIAL PINION THRUST WASHER

a.
C232580

Using a micrometer, measure the thickness of the front differential pinion thrust washer.

Minimum thickness:

0.54 mm (0.0213 in.)


If the thickness is less than the minimum, replace the front differential pinion thrust washer.


Hide 41342F 3.INSPECT FRONT NO. 1 DIFFERENTIAL PINION SHAFT

a.
C232581

Using a micrometer, measure the outer diameter of the front No. 1 differential pinion shaft.

Minimum outer diameter:

14.975 mm (0.590 in.)


If the outer diameter is less than the minimum, replace the front No. 1 differential pinion shaft.