Home › Power Source / Network › 1KR-FE (BATTERY / CHARGING) › GENERATOR (for 80A Type) › from 2020.07
RM36W0E _57 Power Source / Network _090846 1KR-FE BATTERY / CHARGING _0432212 GENERATOR(for 80A Type) A

1KR-FE BATTERY / CHARGING  GENERATOR(for 80A Type)  INSTALLATION  


PROCEDURE

Hide 27020 1.INSTALL GENERATOR ASSEMBLY

a.

Install the 2 wire harness clamp brackets with the 2 bolts.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)


b.
A331326E04
0.438,1 0.885,1.229 0.448,0.229 10 true A (1) 0.927,1.823 1.375,2.052 0.448,0.229 10 true B (2) 2.063,1.844 2.51,2.073 0.448,0.229 10 true B (3)

Temporarily install the generator assembly and generator bracket to the timing chain cover sub-assembly with the 3 bolts.

Torque:
Bolt (A) : 54 N*m (551 kgf*cm, 40 ft.*lbf)
Bolt (B) : 34 N*m (347 kgf*cm, 25 ft.*lbf)


c.

Tighten the 3 bolts in the sequence shown in the illustration.


d.

Connect the compressor with pulley assembly connector.


e.

Engage the 2 clamps to connect the wire harness to the 2 wire harness clamp brackets.


f.

Connect the wire harness to terminal B with the nut.

Torque:
9.8 N*m (100 kgf*cm, 87 in.*lbf)


g.

Install the terminal cap.


Hide 3.CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

Hide 4. INITIALIZATION AFTER RECONNECTING AUXILIARY BATTERY TERMINAL

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>WORK PROCEDURE

HINT:

When disconnecting and reconnecting the battery, there is an automatic learning function that completes learning when the respective system is used.

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>AUTOMATIC LEARNING CHART