Home › Vehicle Exterior › ACOUSTIC VEHICLE ALERTING SYSTEM › ACOUSTIC VEHICLE ALERTING SYSTEM › from 2020.07
RM36W0E _59 Vehicle Exterior _091206 ACOUSTIC VEHICLE ALERTING SYSTEM _0432211 ACOUSTIC VEHICLE ALERTING SYSTEM U

ACOUSTIC VEHICLE ALERTING SYSTEM  ACOUSTIC VEHICLE ALERTING SYSTEM  DATA LIST / ACTIVE TEST  


DATA LIST


NOTICE:

In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.


HINT:

Using the GTS to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.


a.

Enter the following menus: Body Electrical / Vehicle Proximity Notification System / Data List.


b.

Read the Data List according to the display on the GTS.

Body Electrical > Vehicle Proximity Notification System > Data List
Tester Display Measurement Item Range Normal Condition Diagnostic Note
Total Distance Traveled Actual driven distance 0 to 16777215 Roughly the same as the actual driven distance -
Total Distance Traveled - Unit Actual driven distance unit km or mile Displays the current actual driven distance unit -
Engine Mode Engine condition Stopped, Move to Stopping, Starting, or Running
·

Engine stopped: Stop

·

Move to stopping: Stop Process

·

Starting: Startup Process

·

Running: Running


-
Shift Switch Status Shift state P Range, R Range, N Range, D Range or B Range Matches currently selected shift state: P, R, N, D, B -
Estimated Vehicle Speed Estimated Vehicle Speed 0 to 655 km/h Current value displayed -
Stop Light SW Stop light switch signal OFF or ON OFF: Brake pedal released
ON: Brake pedal depressed
-
IGP IGP power source status OFF or ON OFF: IGP power source voltage is not input to vehicle approaching speaker
ON: IGP power source voltage is input to vehicle approaching speaker
-


ACTIVE TEST


HINT:

Using the GTS to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.


a.

Enter the following menus: Body Electrical / Vehicle Proximity Notification System / Active Test.


b.

Perform the Active Test according to the display on the GTS.

Body Electrical > Vehicle Proximity Notification System > Active Test
Tester Display Measurement Item Control Range Diagnostic Note
Proximity Sound (Vehicle Stationary) 0 km/h (0 mph) vehicle proximity warning sound OFF or ON -
Proximity Sound (5km/h,3MPH) 5 km/h (3 mph) vehicle proximity warning sound OFF or ON -
Proximity Sound (10km/h,6MPH) 10 km/h (6 mph) vehicle proximity warning sound OFF or ON -
Proximity Sound (15km/h,9MPH) 15 km/h (9 mph) vehicle proximity warning sound OFF or ON -
Proximity Sound (20km/h,12MPH) 20 km/h (12 mph) vehicle proximity warning sound OFF or ON -
Proximity Sound (30km/h,18MPH) 30 km/h (18 mph) vehicle proximity warning sound OFF or ON -
Proximity Sound (Reverse 6km/h,3.6MPH) 6 km/h (4 mph) reversing vehicle proximity warning sound OFF or ON -