Home › Power Source / Network › M15A-FKS (BATTERY / CHARGING) › GENERATOR (for 120A Type) › from 2020.07
RM36W0E _57 Power Source / Network _087763 M15A-FKS BATTERY / CHARGING _0432222 GENERATOR(for 120A Type) A

M15A-FKS BATTERY / CHARGING  GENERATOR(for 120A Type)  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the generator with regulator assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedures Effect/Inoperative Function when Necessary Procedure not Performed Link
Auxiliary battery terminal is disconnected/reconnected Memorize steering angle neutral point Parking assist monitor system (Click here)

HINT:

When the cable is disconnected / reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.

·

Learning completes when vehicle is driven

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Lane tracing assist system Drive the vehicle straight ahead at 35 km/h (22 mph) or more for 5 seconds or more. (Click here)
Pre-collision system

·

Learning completes when vehicle is operated normally

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Power door lock control system
·

Back door opener


Perform door unlock operation with door control switch or electrical key transmitter sub-assembly switch. (Click here)
Air conditioning system After the ignition switch is turned to ON, the servo motor standard position is recognized. -



PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal.

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>BEFORE DISCONNECTING BATTERY


Hide 2.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

Hide 16361A 3.REMOVE V-RIBBED BELT

Hide 27020 4.REMOVE GENERATOR WITH REGULATOR ASSEMBLY

a.
A464210

Disengage the clamp.


b.

Disconnect the 2 connectors.


c.

Open the terminal cap.


d.

Remove the nut and disconnect the wire harness from terminal B.


e.

Remove the bolt and separate the wire harness clamp bracket from the generator with regulator assembly.


f.
A464211

Remove the 2 nuts, bolt and generator with regulator assembly.