Home › Drivetrain › K320 (MULTIDRIVE / CVT) › OIL PAN › from 2020.07
RM36W0E _52 Drivetrain _087836 K320 MULTIDRIVE / CVT _0422059 OIL PAN A

K320 MULTIDRIVE / CVT  OIL PAN  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the transaxle side cover sub-assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedure Effect/Inoperative when not Performed Link
Air intake system parts Inspection After Repair
·

Poor idle, etc.

·

Engine start function, etc.


(Click here)
Replacement of CVT fluid
w/ Stop and Start System:

Bleed air from oil pump (continuously variable transaxle assembly)


Stop and Start System (Click here)
ATF thermal degradation estimate reset The value of the Data List item "ATF Thermal Degradation Estimate" is not estimated correctly (Click here)

PROCEDURE

Hide 51451A 1.REMOVE CENTER ENGINE UNDER COVER

Hide 51442C 2.REMOVE ENGINE UNDER COVER LH

Hide 3.DRAIN CONTINUOUSLY VARIABLE TRANSAXLE FLUID

a.
C428807

Remove the refill plug and gasket from the rear transaxle case sub-assembly.


b.
C428803

Using a 10 mm hexagon socket wrench, remove the overflow plug and gasket from the transaxle case sub-assembly.


c.
C428804C01
2.375,0.844 2.656,0.844 true 2.219,0.771 2.448,1 0.229,0.229 10 false *1
*1 Overflow (CVT) Tube


Using a 6 mm hexagon socket wrench, remove the overflow (CVT) tube from the transaxle case sub-assembly.

HINT:

Removing the overflow (CVT) tube will drain all oil in the transaxle case sub-assembly.



d.

Using a 6 mm hexagon socket wrench, install the overflow (CVT) tube to the transaxle case sub-assembly.

Torque:
0.8 N*m (8 kgf*cm, 7 in.*lbf)


e.

Using a 10 mm hexagon socket wrench, temporarily install the overflow plug and gasket to the transaxle case sub-assembly.

HINT:

Reuse the old gasket as the overflow plug will be removed again to adjust the fluid level.



f.

Temporarily install the gasket and refill plug to the rear transaxle case sub-assembly.

HINT:

Reuse the old gasket as the refill plug will be removed again to adjust the fluid level.



Hide 17705 4.REMOVE AIR CLEANER CAP WITH AIR CLEANER HOSE

Hide 17701 5.REMOVE AIR CLEANER CASE SUB-ASSEMBLY

Hide 82121 6.REMOVE ENGINE WIRE

a.
C428865

Disengage the 2 clamps to disconnect the engine wire from the continuously variable transaxle assembly.


Hide 7.INSTALL WIRE HARNESS CLAMP BRACKET

a.
C428866

Remove the bolt and the wire harness clamp bracket from the continuously variable transaxle assembly.


Hide 35015Y 8.REMOVE TRANSAXLE SIDE COVER SUB-ASSEMBLY

a.
C428867

Remove the 11 bolts and transaxle side cover sub-assembly from the transaxle case sub-assembly.


b.
C395511

Remove the O-ring from the transaxle side cover sub-assembly.