Home › Brake › BRAKE SYSTEM (OTHER) › VACUUM PUMP (for TMMF Made) › from 2020.07
RM36W0E _54 Brake _088656 BRAKE SYSTEM (OTHER) _0432280 VACUUM PUMP(for TMMF Made) G

BRAKE SYSTEM (OTHER)  VACUUM PUMP(for TMMF Made)  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 1. OPERATION CHECK

a.
C436835C01
2.542,3.656 2.177,3.802 2.177,3.802 2.542,3.396 true 1.99,3.729 2.302,3.885 0.313,0.156 10 false *a
*a Retainer
V100135

Pinch
V113148

Pull off


Pinch the retainer of the No. 1 vacuum hose connector, and then pull the No. 1 vacuum hose connector off of the vacuum pump assembly.

NOTICE:

Be sure to disconnect the No. 1 vacuum hose connector by hand.



b.
C436836C01
0.396,1.25 0.396,0.833 true 1.219,0.198 1.552,0.198 true 1.573,0.104 1.75,0.281 0.177,0.177 10 true *a 0.313,1.25 0.51,1.417 0.198,0.167 10 true *b
*a Vacuum Gauge
*b Plug


Connect the hose of the vacuum gauge to the vacuum pump assembly.


c.

Start the engine and warm it up for more than 2 minutes.


d.

With the engine idling, check the vacuum of the vacuum pump assembly.

Standard Pressure:

More than 86.7 kPa (650 mmHg, 25.6 in.Hg)


HINT:
·

If the pressure is less than the standard, replace the vacuum pump assembly.

·

Always perform this operation check procedure after replacing the vacuum pump assembly.




e.

Remove the vacuum gauge from the vacuum pump assembly.


f.

Align the No. 1 vacuum hose connector with the vacuum pump assembly, and push them together until the No. 1 vacuum hose connector makes a "click" sound.