Home › Brake › BRAKE SYSTEM (OTHER) › VACUUM WARNING SWITCH (for Gasoline Model LHD) › from 2020.07
RM36W0E _54 Brake _088656 BRAKE SYSTEM (OTHER) _0432282 VACUUM WARNING SWITCH(for Gasoline Model LHD) A

BRAKE SYSTEM (OTHER)  VACUUM WARNING SWITCH(for Gasoline Model LHD)  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during vacuum warning switch assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedure Effect/Inoperative when not Performed Link
Auxiliary battery terminal is disconnected/reconnected Memorize steering angle neutral point Parking Assist Monitor System (Click here)

HINT:

When the cable is disconnected / reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.

·

Learning completes when vehicle is driven

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Lane tracing assist system Drive the vehicle straight ahead at 35 km/h (22 mph) or more for 5 second or more. (Click here)
Pre-collision system
Stop and start system Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes) (Click here)

·

Learning completes when vehicle is operated normally

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Power door lock control system
·

Back door opener


Perform door unlock operation with door control switch or electrical key transmitter sub-assembly switch. (Click here)
Air conditioning system After the ignition switch is turned to ON, the servo motor standard position is recognized. -



PROCEDURE

Hide 83390H 2.REMOVE VACUUM WARNING SWITCH ASSEMBLY

a.
C436843

Disconnect the connector from the vacuum warning switch assembly.


b.

Remove the vacuum warning switch assembly from the brake booster assembly.


Hide 83390J 3.REMOVE VACUUM WARNING SWITCH GROMMET

a.

Remove the vacuum warning switch grommet from the brake booster assembly.