The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the No. 2 air fuel ratio sensor removal/installation are shown below.
When the engine is hot, do not touch high-temperature areas such as the engine or exhaust pipe.
Touching high-temperature areas such as the engine and exhaust pipe could result in burns.
51447D
1.REMOVE CENTER NO. 4 ENGINE UNDER COVER (for TMC Made)
51447D
2.REMOVE CENTER NO. 4 ENGINE UNDER COVER (for TMMF Made)
57543C
3.REMOVE CENTER NO. 1 FLOOR BRACE (for TMMF Made)
Remove the 2 nuts and front floor center brace from the vehicle body.
4.REMOVE WIRE HARNESS CLAMP BRACKET
Disengage the guide to disconnect the wire harness from the wire harness clamp bracket.
Remove the wire harness clamp bracket from the No. 2 air fuel ratio sensor.
89467C
5.REMOVE NO. 2 AIR FUEL RATIO SENSOR
Disconnect the No. 2 air fuel ratio sensor connector.
Disengage the 2 wire harness clamps.
Using SST, remove the No. 2 air fuel ratio sensor from the front exhaust pipe assembly.
If the No. 2 air fuel ratio sensor has been struck or dropped, replace it.