Home › Engine / Hybrid System › M15A-FXE (EMISSION CONTROL) › DIFFERENTIAL PRESSURE SENSOR › from 2020.07
RM36W0E _51 Engine / Hybrid System _088663 M15A-FXE EMISSION CONTROL _0432611 DIFFERENTIAL PRESSURE SENSOR A

M15A-FXE EMISSION CONTROL  DIFFERENTIAL PRESSURE SENSOR  INSTALLATION  


PROCEDURE

Hide 25760 1.CONNECT VACUUM TRANSMITTING HOSE ASSEMBLY

a.

Connect the vacuum transmitting hose assembly to the No. 1 tube and slide the clip to secure the hose.


Hide 89481B 2.INSTALL DIFFERENTIAL PRESSURE SENSOR

a.

Install the sensor bracket to the fuel pump flange with the nut.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)


b.

Install the differential pressure sensor to the sensor bracket with the nut.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)

HINT:

Make sure there is no oil on the bracket.



c.
A468016C01
0.229,1.354 0.542,1.51 0.313,0.156 10 false *a 0.958,0.823 1.271,0.979 0.313,0.156 10 false *b 0.344,1.583 0.656,1.74 0.313,0.156 10 false *c
*a Rear of Vehicle
*b Right Side of Vehicle
*c 90°


Connect the vacuum transmitting hose assembly to the differential pressure sensor and slide the clip to secure it.

HINT:

Install the vacuum transmitting hose assembly and hose clamps as shown in the illustration.



d.

Connect the 2 clamps and differential pressure sensor connector.


Hide 89481B 3.LEARNING DIFFERENTIAL PRESSURE SENSOR

a.

Start the engine and allow it to idle until the engine coolant temperature reaches 75°C (167°F) or higher (A).


b.

Turn the engine switch off and wait for 30 seconds or more (B).


c.

Repeat the above procedures (A) and (B) 3 times.

HINT:

Procedures (A) and (B) must be repeated 3 times to complete the differential pressure sensor learning process.