Use the same procedure for RHD and LHD vehicles.
The following procedure is for LHD vehicles.
55480D
1.REMOVE LOWER INSTRUMENT PANEL FINISH PANEL ASSEMBLY
55406B
2.REMOVE INSTRUMENT CLUSTER FINISH LOWER CENTER PANEL SUB-ASSEMBLY
Disengage the clips to separate the instrument cluster finish lower center panel sub-assembly.
for Single Layer Type:
Disconnect the 3 connectors.
for Double Layer Type:
Disconnect the 4 connectors.
for Single Layer Type:
Disengage the claws to remove the instrument cluster finish lower center panel sub-assembly.
for Double Layer Type:
Disengage the claws to remove the instrument cluster finish lower center panel sub-assembly.
55902E
3.REMOVE NO. 2 HEATER CONTROL SUB-ASSEMBLY
Disengage the claws to remove the No. 2 heater control sub-assembly.
55903A
4.REMOVE NO. 3 HEATER CONTROL SUB-ASSEMBLY
Disengage the claws to remove the No. 3 heater control sub-assembly.
Before removing the No. 3 heater control sub-assembly, make sure to set it to MAX COLD.
55901D
5.REMOVE NO. 1 HEATER CONTROL SUB-ASSEMBLY
Disengage the claws to remove the No. 1 heater control sub-assembly.
Before removing the No. 1 heater control sub-assembly, make sure to set the mode switch to FACE.